PixArt Imaging Inc.
ADBS-A350 Optical Finger Navigation
OFN_Engine2
Access: Read/Write
Address: 0x61
Reset Value: 0x89
7
6
5
4
3
2
1
0
Bit
Reserved
Reserved
FPD_Rest_
Wake1
FPD_Rest_
Wake0
FPD_Mot_
Cut
Reserved
PAD_Chk On FPD_SQ_EN
Field
Data Type: Bit field
USAGE: This register is used to set several properties of the sensor related to FPD function.
Field Name
Description
FPD_Rest_Wake1:0 Wakes up from rest with FPD
0 = FPD rest wake up disabled
1 = Wake up when finger is present OR motion is detected
2 = Wake up when finger is present AND motion is detected
FPD_Mot_Cut
In FPD enabled mode, cut off motion when finger is not detected and shutter is
below preset value.
Shutter preset value can configured by SHUT_CUTOFF_THRES in FPD_CTRL
(register 0x75).
0 = Disable FPD_Mot_Cut
1 = Enable FPD_Mot_Cut
PAD_Chk_On
FPD_SQ_EN
Enable this bit for PAD_STATUS check
To improve FPD on low reflectance surface by comparing the instantaneous
Squal value with a threshold set in FPD_SQUAL_THRESH (register 0x78).
0 = Disable FPD_SQ_EN
1 = Enable FPD_SQ_EN
Resolution
Access: Read/Write
Address: 0x62
Reset Value: 0x32
7
6
5
4
3
2
1
0
Bit
WakeRES3
WakeRES2
WakeRES1
WakeRES0
RES3
RES2
RES1
RES0
Field
Data Type: Bit field
USAGE: This register is used to set several properties of the sensor.
Field Name
Description
WakeRES3:0
Sets resolution when sensor wakes up from rest modes. Effective only when
speed switching is enabled.
0x00 : 125 cpi 0x05 : 1250 cpi
0x01 : 250 cpi
0x02 : 500 cpi
0x03 : 750 cpi
0x04 : 1000 cpi
RES3:0
Sets resolution of sensor.
0x00 : 125 cpi 0x05 : 1250 cpi
0x01 : 250 cpi
0x02 : 500 cpi
0x03 : 750 cpi
0x04 : 1000 cpi
If Speed switching is enabled, resolution is automatically switched from
250-500-750-1000-1250.
If speed switching is disabled, this register can be set to any of the available
settings from 0x0 to 0x5.
All rights strictly reserved any portion in this paper shall not be reproduced, copied or transformed to any other forms without permission.
45
PixArt Imaging Inc.
E-mail: fae_service@pixart.com.tw