• Click the button Enable All Ports below the table, the port Output-LEDs will be turned on if
connected to a valid device or it will display a status “No Connection” if a port is not connected
to a valid end device.
• Click the button Disable All Ports below the table, all port Output-LEDs will be turned off.
• Click the button Cycle All Ports in the last row, all port Output-LEDs will follow one of the following
actions: If the ports are already “ON” then the ports will be “On” (or No Connection) » Off »
Turning On… » On (or No Connection). If all ports start turned off then the sequence will be Off
» Turning On… » On (No Connection), depends on their original states.
Phihong USA Corporation • 47800 Fremont Blvd. Fremont, CA 94538 • Tel: 1.510.445.0100 Fax: 1.510.445.1678
www.phihong.com or www.midspans.com
-20-
PHIHONG [ PHIHONG USA INC. ]
