Release
by
PARALIGHTDCC
0.43 INCH SINGLE DIGIT DISPLAY
REV:A / 0
C-431E G/W
2) Use Display with holder made of resin (Fig.4) to position the PIN.
Fig.4
—FORMED LEAD
1) The PIN should be bent at a point located at least 2mm away from the package. Bending should
be performed with base fixed means of a jig or pliers (Fig.5)
Fig.5
2) Forming PIN should be carried our prior to soldering and never during or after soldering.
3) Form the PIN to ensure alignment between the PIN and the hole on board, so that stress against
the Display is prevented. (Fig.6)
Fig.6
DRAWING NO. : DS-11-10-0052
DATE : 2010-06-17
Page : 7
PARALIGHT [ PARA LIGHT ELECTRONICS CO., LTD. ]
