SPECIFICATION
Product Name：LED Downlight
L
For Figure A1 circuit, after removing the starter, the LED tube can be installed directly onto the G13 base
For Figure B1 circuit, please removing the electronic ballast, and connect L and N to the joints in the base
separately
After adjusting the circuit, install the LED tube in the same way as installing the traditional fluorescent tube
light.
Turn on the power supply of the base to check whether the tube light is working properly or not.
Precautions
LEDs are static sensitive devices. Precautions should be taken to ensure that LEDs are well protected from
ESD during handling.
ESD protection for GaP and AlGaAS based chips is still necessary even though the chips are safe in low
static-electric discharge events
AllnGap, GaN and/or InGaN based chips are STATIC SENSITIVE devices and ESD protection must be taken into
consideration in the initial design stages.
Do not operate LEDs in reverse bias.
Warranty and Liability Information
Two years limited warranty.
The information contained herein is presented only as a guide for the applications of our products.
No responsibility is assumed by factory for any infringements of intellectual property or other infringements of
- 9 -
P-TEC [ P-tec Corporation ]
