H8PS
■ Functions
Item
H8PS-8@
H8PS-16@
H8PS-32@
Encoder rotation direction
switching
Encoder data can be set with a DIP switch to forward (CW) or reverse (CCW) direction.
Encoder origin designation
The present display angular
The present display angular position can be set to 0° (origin) by using the
position can be set to 0° (origin) by origin input terminal or the ORIGIN Key on the front panel.
pressing the ORIGIN Key on the
Note: All banks use the same origin.
front panel.
Angle display switch
Rotation display monitor
Teaching function
Pulse output
Converts the Absolute Encoder value display from 256 divisions/revolution to 360°/revolution.
Graphically displays the Encoder rotational angular position.
Sets the cam output ON/OFF angle based on actual machine (Encoder) operation.
Outputs a preset number of pulses per Encoder rotation. It also sets the pulse output start angle.
Switching the angle and
speed displays
Displays both the present angular position and the number of Encoder revolutions (speed) in Run Mode.
Switches back and forth between the main display showing the present angular position with the sub-display
showing the speed and the main display showing the speed with the sub-display showing the present angular
position.
Bank function
---
Enables the entire cam program to be changed at one time by switching
banks (0 to 7).
The bank that is running can be switched using the bank input terminal or the
BANK Key on the front panel.
Also enables programs to be copied between banks.
Advance anglecompensation Automatically advances the ON/OFF angle of cam outputs in proportion to machine (encoder) speed to
(ADV) function
compensate for the delay in timing of ON/OFF operation. ADV values can be set individually for 7 cam outputs.
Speed alarm output
A specified cam output can be used as an Encoder speed alarm output.
The function can output upper and lower limit speed alarms.
All protection function
Cam protection function
Step number limit
Disables all key and switch operations in Run Mode to prevent incorrect or unauthorized operation.
Prohibits program changes at the cam output level. Any cam numbers can be protected.
Limits the number of steps that can be set per cam output. Prohibits incorrect operations by adding to the
program.
Output prohibit
---
The start input can be turned OFF in Run or Test Mode to prohibit cam
output.
Note: Use this function carefully for the application because no cam outputs
are provided when the start input is turned OFF.
Support Software settings
---
Programs can be uploaded or downloaded easily by connecting a personal
computer to the Cam Positioner using a USB Cable (Recommended USB
Cables: ELECOM CO.Ltd. U2C-MF20BK) and the Support Software (H8PS-
SOFT-V1, sold separately).
5
OMRON [ OMRON ELECTRONICS LLC ]
