A16/M16
A16/M16
Installation
J MOUNTING
J REPLACEMENT PARTS
After mounting the Pushbutton Unit to the panel, snap in the
Socket Unit from the back of the panel.
Removal and installation of the Operating Part
1. Remove the operating part as shown in the following
diagram. If the operating part cannot be removed by hand,
use the A3PJ-5080 Extractor.
Panel mounting
Insert the Pushbutton Unit into the front of the panel, and fix the
lock ring and mounting nut from the terminal side.
Make sure that the lock ring is aligned with the thread of the case
and the edge of the lock ring is touching the panel.
Tighten the mounting nuts to a torque of 0.20 to 0.39 N • m (3 to
5 kgf • cm).
The maximum tightening torque is 0.39 N • m (5 kgf • cm).
Operating section
Panel
Mounting nut
Case
Thread
2. To attach the operating part, push until it clicks into place.
J REMOVING THE LAMP
Removing from the Operating Part End
Lamp
Lock ring
Edge
Switch Mounting
Snap on the Switch Unit to the Pushbutton Unit.
Make sure the the Switch Unit is in the proper orientation when
snapping on to the Pushbutton Unit.
Grip the Lamp with the
A16Z-5080 Extractor and
pull to remove.
Removing from the Switch Unit End
The Lamp can be removed by hand once the Switch is removed
using the A16Z-5080 Extractor.
J INSTALLING THE LAMP
When mounting the Lamp, make sure it is facing the direction
shown in the following diagram. Insert the Lamp while matching
the protruding part of the Lamp and the small guides on the outer
surface of the case.
J SWITCH REMOVAL
Grip the part between the Switch holder of the case and the
Switch Unit using the A16Z-5080 Extractor, and pull to remove
the Switch Unit.
Protruding part
The Lamp can be mounted from the operating part end by using
the A16Z-5080 Extractor. The lamp can be mounted by following
the opposite procedure for removing the Lamp.
A16Z-5080 Extractor
21
OMRON [ OMRON ELECTRONICS LLC ]
