Preparing for Operation
Chapter 4
Stop Key Selection
n61
Setting range 0, 1
Factory setting 0
• When inputting Inverter operation from the control terminals, the Stop Key on the Digi-
tal Operator can be set to “enabled” or “disabled.”
Value
Description
0
1
Stop Key enabled
Stop Key disabled
Note 1. When operating the Inverter from the Digital Operator, the Stop Key is always
enabled irrespective of its setting.
Note 2. This constant is available for models with a PROM number (software version)
of “200” or higher.
Operator’s Frequency Setting Method
n64
Setting range 0, 1
Factory setting 0
• Used for setting the frequency from the Digital Operator.
• Select the Enter Key operation when setting the frequency command from the Digital
Operator.
Value
Description
0
1
Enter Key required for changing frequency
Enter Key not required for changing frequency (may be changed using
Increment and Decrement Keys.)
Error History
n68
This constant can only be displayed. It cannot be set.
• Information about the last error is recorded in this constant. Use this information for
troubleshooting purposes.
• The display format is as follows:
8.8.8.
Error code
Note This constant is available for models with a PROM number (software version) of
“220” or higher.
4-23
OMRON [ OMRON ELECTRONICS LLC ]
