¡ Semiconductor
ML9041
PIN DESCRIPTIONS
Symbol
Description
R/W
The input pin with a pull–up resistor to select Read (“H”) or Write (“L”) in the Parallel
I/F Mode.
This pin should be open in the Serial I/F Mode.
RS0, RS1
The input pins with a pull–up resistor– to select a register in the Parallel I/F Mode.
RS
H
1
RS0
H
Name of register
Data register
H
L
Instruction register
L
L
Expansion Instruction register
This pin should be open in the Serial I/F Mode.
E
The input pin for data input/output between the CPU and the ML9041 and for activating
instructions in the Parallel I/F Mode.
This pin should be open in the Serial I/F Mode.
DB0 to DB3
The input/output pins to transfer data of lower–order 4 bits between the CPU and the
ML9041 in the Parallel I/F Mode. Each pin is equipped with a pull–up resistor. These 4
lines are not used for the 4–bit interface.
This pin should be open in the Serial I/F Mode.
DB4 to DB7
The input/output pins to transfer data of upper 4 bits between the CPU and the ML9041
in the Parallel I/F Mode. Each pin is equipped with a pull–up resistor.
This pin should be open in the Serial I/F Mode.
OSC1
OSC2
OSCR
The clock oscillation pins required for LCD drive signals and the operation of the
ML9041 by instructions sent from the CPU.
To input external clock, the OSC1 pin should be used. The OSCR and the OSC2 pins
should be open.
To start oscillation with an external resistor, the resistor should be connected between
the OSC1 and OSC2 pins. The OSCR pin should be open.
To start oscillation with an internal resistor, the OSC2 and OSCR pins should be
short–circuited outside the ML9041. The OSC1 pin should be open.
COM1 to COM17
SEG1 to SEG100
The LCD common signal output pins.
For 1/9 duty, non–selectable voltage waveforms are output via COM10 to COM17. For
1/12 duty, non–selectable voltage waveforms are output via COM13 to COM17.
The LCD segment signal output pins.
4/54
OKI [ OKI ELECTRONIC COMPONETS ]
