M28W160CT, M28W160CB
BUS OPERATIONS
There are six standard bus operations that control
the device. These are Bus Read, Bus Write, Out-
put Disable, Standby, Automatic Standby and Re-
set. See Table 3, Bus Operations, for a summary.
Typically glitches of less than 5ns on Chip Enable
or Write Enable are ignored by the memory and do
not affect bus operations.
See Figures 10 and 11, Write AC Waveforms, and
Tables 17 and 18, Write AC Characteristics, for
details of the timing requirements.
Output Disable. The data outputs are high im-
pedance when the Output Enable is at V .
IH
Standby. Standby disables most of the internal
circuitry allowing a substantial reduction of the cur-
rent consumption. The memory is in stand-by
Read. Read Bus operations are used to output
the contents of the Memory Array, the Electronic
Signature, the Status Register and the Common
Flash Interface. Both Chip Enable and Output En-
when Chip Enable is at V and the device is in
IH
read mode. The power consumption is reduced to
the stand-by level and the outputs are set to high
impedance, independently from the Output Enable
or Write Enable inputs. If Chip Enable switches to
able must be at V in order to perform a read op-
IL
eration. The Chip Enable input should be used to
enable the device. Output Enable should be used
to gate data onto the output. The data read de-
pends on the previous command written to the
memory (see Command Interface section). See
Figure 9, Read Mode AC Waveforms, and Table
16, Read AC Characteristics, for details of when
the output becomes valid.
V
during a program or erase operation, the de-
IH
vice enters Standby mode when finished.
Automatic Standby. Automatic Standby pro-
vides a low power consumption state during Read
mode. Following a read operation, the device en-
ters Automatic Standby after 150ns of bus inactiv-
ity even if Chip Enable is Low, V , and the supply
IL
Read mode is the default state of the device when
exiting Reset or after power-up.
current is reduced to I
. The data Inputs/Out-
DD1
puts will still output data if a bus Read operation is
in progress.
Write. Bus Write operations write Commands to
the memory or latch Input Data to be programmed.
A write operation is initiated when Chip Enable
Reset. During Reset mode when Output Enable
is Low, V , the memory is deselected and the out-
IL
and Write Enable are at V with Output Enable at
puts are high impedance. The memory is in Reset
IL
V . Commands, Input Data and Addresses are
mode when Reset is at V . The power consump-
IH
IL
latched on the rising edge of Write Enable or Chip
tion is reduced to the Standby level, independently
Enable, whichever occurs first.
from the Chip Enable, Output Enable or Write En-
able inputs. If Reset is pulled to V during a Pro-
SS
gram or Erase, this operation is aborted and the
memory content is no longer valid.
Table 3. Bus Operations
V
Operation
Bus Read
E
G
W
RP
WP
X
DQ0-DQ15
Data Output
Data Input
Hi-Z
PP
V
V
V
V
Don't Care
V or V
DD
IL
IL
IL
IL
IH
IH
IH
IH
V
V
V
V
V
V
V
V
Bus Write
Output Disable
Standby
X
IL
IH
PPH
V
X
Don't Care
Don't Care
Don't Care
IH
IH
V
X
X
X
Hi-Z
IH
IH
V
Reset
X
X
X
X
Hi-Z
IL
Note: X = V or V , V = 12V 5%.
PPH
IL
IH
10/50
NUMONYX [ NUMONYX B.V ]
