M25PX16
Signal descriptions
If the W/VPP input is kept in a low voltage range (0 V to VCC) the pin is seen as a control
input. This input signal is used to freeze the size of the area of memory that is protected
against program or erase instructions (as specified by the values in the BP2, BP1 and BP0
bits of the Status Register. See Table 9).
If VPP is in the range of VPPH (as defined in Table 14) it acts as an additional power
supply.(2)
2.7
2.8
VCC supply voltage
VCC is the supply voltage.
VSS ground
VSS is the reference for the VCC supply voltage.
2. Avoid applying VPPH to the W/VPP pin during Bulk Erase.
9/61