欢迎访问ic37.com |
会员登录 免费注册
发布采购

800FT 参数 Datasheet PDF下载

800FT图片预览
型号: 800FT
PDF下载: 下载PDF文件 查看货源
内容描述: 顶部/底部引导块5 V电源快闪记忆体 [Top / Bottom Boot Block 5 V Supply Flash Memory]
分类和应用:
文件页数/大小: 67 页 / 1730 K
品牌: NUMONYX [ NUMONYX B.V ]
 浏览型号800FT的Datasheet PDF文件第2页浏览型号800FT的Datasheet PDF文件第3页浏览型号800FT的Datasheet PDF文件第4页浏览型号800FT的Datasheet PDF文件第5页浏览型号800FT的Datasheet PDF文件第7页浏览型号800FT的Datasheet PDF文件第8页浏览型号800FT的Datasheet PDF文件第9页浏览型号800FT的Datasheet PDF文件第10页  
Description  
M29FxxxFT, M29FxxxFB  
1
Description  
®
The following overview of the Numonyx Axcell™ M29F 5 V Flash Memory device  
(M29W160F) refers to the 16-Mbit device. However, the information can also apply to lower  
densities of the M29F device.  
The M29F160F is a 16 Mbit (2 Mbit x8 or 1 Mbit x16) non-volatile memory that can be read,  
erased and reprogrammed. These operations can be performed using a single low voltage  
(4.5 to 5.5 V) supply. On power-up the memory defaults to its Read mode where it can be  
read in the same way as a ROM or EPROM.  
The memory is divided into blocks that can be erased independently so it is possible to  
preserve valid data while old data is erased. Each block can be protected independently to  
prevent accidental Program or Erase commands from modifying the memory. Program and  
Erase commands are written to the Command Interface of the memory. An on-chip  
Program/Erase Controller simplifies the process of programming or erasing the memory by  
taking care of all of the special operations that are required to update the memory contents.  
The end of a program or erase operation can be detected and any error conditions  
identified. The command set required to control the memory is consistent with JEDEC  
standards.  
The blocks in the memory are asymmetrically arranged, as shown in Figure 10.: Block  
Addresses, M29F160 (x8) and Figure 11.: Block Addresses, M29F160 (x16). The first or last  
64 KBytes have been divided into four additional blocks. The 16 KByte Boot Block can be  
used for small initialization code to start the microprocessor, the two 8 KByte Parameter  
Blocks can be used for parameter storage and the remaining 32K is a small Main Block  
where the application may be stored.  
Chip Enable, Output Enable and Write Enable signals control the bus operation of the  
memory. They allow simple connection to most microprocessors, often without additional  
logic.  
The memory is offered in TSOP48 (12 x 20mm), SO44 , and TFBGA48 (0.8 mm pitch)  
packages. The memory is supplied with all the bits erased (set to ’1’).  
6/67