Note 5: LM75 θ (thermal resistance, junction-to-ambient) when attached to a printed circuit board with 2 oz. foil similar to the one shown in Figure 3 is summarized
JA
in the table below:
NS Package
Number
M08A
Thermal
Resistance (θJA
200˚C/W
Device Number
)
LM75BIM-3, LM75BIM-5, LM75CIM-3, LM75CIM-5
LM75BIMM-3, LM75BIMM-5, LM75CIMM-3, LM75CIMM-5
MUA08A
250˚C/W
Note 6: All part numbers of the LM75 will operate properly over the +V supply voltage range of 3V to 5.5V. The devices are tested and specified for rated accuracy
S
at their nominal supply voltage. Accuracy will typically degrade 1˚C/V of variation in +V as it varies from the nominal value.
S
Note 7: Limits are guaranteed to National’s AOQL (Average Outgoing Quality Level).
Note 8: This specification is provided only to indicate how often temperature data is updated. The LM75 can be read at any time without regard to conversion state
(and will yield last conversion result). If a conversion is in process it will be interrupted and restarted after the end of the read.
Note 9: For best accuracy, minimize output loading. Higher sink currents can affect sensor accuracy with internal heating. This can cause an error of 0.64˚C at full
rated sink current and saturation voltage based on junction-to-ambient thermal resistance.
Note 10: O.S. Delay is user programmable up to 6 “over limit” conversions before O.S. is set to minimize false tripping in noisy environments.
Note 11: Default values set at power up.
Note 12: Typicals are at T = 25˚C and represent most likely parametric norm.
A
Note 13: Holding the SDA line low for a time greater than t
will cause the LM75B to reset SDA to the IDLE state of the serial bus communication (SDA set
TIMEOUT
High).
01265805
FIGURE 2. Temperature-to-Digital Transfer Function (Non-linear scale for clarity)
www.national.com
6
NSC [ National Semiconductor ]
