If no filter capacitors are used at the analog inputs and the
signal source impedances are low, the comparator input cur-
rent should not introduce converter errors, as the transient
created by the capacitance discharge will die out before the
comparator output is strobed.
Applications Information (Continued)
4.0 ANALOG COMPARATOR INPUTS
The dynamic comparator input current is caused by the pe-
riodic switching of on-chip stray capacitances. These are
connected alternately to the output of the resistor ladder/
switch tree network and to the comparator input as part of
the operation of the chopper stabilized comparator.
If input filter capacitors are desired for noise reduction and
signal conditioning they will tend to average out the dynamic
comparator input current. It will then take on the characteris-
tics of a DC bias current whose effect can be predicted con-
ventionally.
The average value of the comparator input current varies di-
rectly with clock frequency and with VIN as shown in
Figure 6.
Typical Application
DS005672-10
*Address latches needed for 8085 and SC/MP interfacing the ADC0808 to a microprocessor
MICROPROCESSOR INTERFACE TABLE
PROCESSOR
READ
WRITE
INTERRUPT (COMMENT)
INTR (Thru RST Circuit)
INTR (Thru RST Circuit)
INT (Thru RST Circuit, Mode 0)
SA (Thru Sense A)
8080
MEMR
MEMW
8085
RD
WR
Z-80
RD
WR
SC/MP
6800
NRDS
VMA•φ2•R/W
NWDS
VMA•φ•R/W
IRQA or IRQB (Thru PIA)
Ordering Information
TEMPERATURE RANGE
−40˚C to +85˚C
−55˚C to +125˚C
1
±
±
Error
⁄2
LSB Unadjusted ADC0808CCN
ADC0809CCN
N28A Molded DIP
ADC0808CCV
ADC0808CCJ
ADC0808CJ
1 LSB Unadjusted
ADC0809CCV
Package Outline
V28A Molded Chip Carrier
J28A Ceramic DIP
J28A Ceramic DIP
www.national.com
12
NSC [ National Semiconductor ]
