Functional Description
Truth Tables
The ABT16373 contains sixteen D-type latches with
TRI-STATE standard outputs. The device is byte controlled
with each byte functioning identically, but independent of the
other. Control pins can be shorted together to obtain full
16-bit operation. The following description applies to each
byte. When the Latch Enable (LEn) input is HIGH, data on
the Dn enters the latches. In this condition the latches are
transparent, i.e., a latch output will change states each time
its D input changes. When LEn is LOW, the latches store in-
formation that was present on the D inputs a setup time pre-
ceding the HIGH-to-LOW transition of LEn. The TRI-STATE
standard outputs are controlled by the Output Enable (OEn)
input. When OEn is LOW, the standard outputs are in the
2-state mode. When OEn is HIGH, the standard outputs are
in the high impedance mode but this does not interfere with
entering new data into the latches.
Inputs
Outputs
LE1
X
OE1
H
D0–D7
O0–O7
X
L
Z
H
L
L
H
H
L
H
X
L
L
(Previous)
Inputs
Outputs
LE2
X
OE2
H
D8–D15
O8–O15
X
L
Z
H
L
L
H
H
L
H
X
L
L
(Previous)
=
=
=
=
H
L
X
Z
High Voltage Level
Low Voltage Level
Immaterial
High Impedance
=
Previous previous output prior to HIGH to LOW transition of LE
Logic Diagrams
DS100201-3
DS100201-4
www.national.com
2