Processor Programming (Continued)
3.3.2.3 Debug Registers
The Debug Address Registers (DR0-DR3) each contain
the linear address for one of four possible breakpoints.
Each breakpoint is further specified by bits in the Debug
Control Register (DR7). For each breakpoint address in
DR0-DR3, there are corresponding fields L, R/W, and
LEN in DR7 that specify the type of memory access asso-
ciated with the breakpoint. DR6 is read only and reports
the results of the break.
Six debug registers (DR0-DR3, DR6 and DR7) support
debugging on the GXLV processor. Memory addresses
loaded in the debug registers, referred to as “breakpoints,”
generate a debug exception when a memory access of
the specified type occurs to the specified address. A
breakpoint can be specified for a particular kind of mem-
ory access such as a read or write operation. Code and
data breakpoints can also be set allowing debug excep-
tions to occur whenever a given data access (read or write
operation) or code access (execute) occurs. The size of
the debug target can be set to 1, 2, or 4 bytes. The debug
registers are accessed through MOV instructions that can
be executed only at privilege level 0 (real mode is always
privilege level 0).
The R/W field can be used to specify instruction execution
as well as data access breakpoints. Instruction execution
breakpoints are always acted upon before execution of
the instruction that matches the breakpoint. The Debug
Registers are mapped in Table 3-12, and the bit defini-
tions are given in Table 3-13 on page 56.
Table 3-12. Debug Registers
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10
9
8
7
6
5
4
3
2
1
0
DR7 Register
Debug Control Register 7 (R/W)
LEN3 R/W3 LEN2 R/W2 LEN1 R/W1 LEN0 R/W0
0
0
G
D
0
0
1
1
1
0
0
G
3
L
3
G
2
L
2
G
1
L
1
G
0
L0
DR6 Register
Debug Status Register 6 (R/O)
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
B
T
B
S
0
1
1
1
1
1
1
1
B3 B2 B1 B0
DR3 Register
DR2 Register
DR1 Register
DR0 Register
Debug Address Register 3 (R/W)
Breakpoint 3 Linear Address
Debug Address Register 2 (R/W)
Breakpoint 2 Linear Address
Debug Address Register 1 (R/W)
Breakpoint 1 Linear Address
Debug Address Register 0 (R/W)
Breakpoint 0 Linear Address
Note: All bits marked as 0 or 1 are reserved and should not be modified.
Revision 1.1
55
www.national.com
NSC [ National Semiconductor ]
