欢迎访问ic37.com |
会员登录 免费注册
发布采购

30151-33 参数 Datasheet PDF下载

30151-33图片预览
型号: 30151-33
PDF下载: 下载PDF文件 查看货源
内容描述: 的Geode ™ GXM处理器与MMX支持集成的x86解决方案 [Geode⑩ GXm Processor Integrated x86 Solution with MMX Support]
分类和应用:
文件页数/大小: 244 页 / 4221 K
品牌: NSC [ National Semiconductor ]
 浏览型号30151-33的Datasheet PDF文件第42页浏览型号30151-33的Datasheet PDF文件第43页浏览型号30151-33的Datasheet PDF文件第44页浏览型号30151-33的Datasheet PDF文件第45页浏览型号30151-33的Datasheet PDF文件第47页浏览型号30151-33的Datasheet PDF文件第48页浏览型号30151-33的Datasheet PDF文件第49页浏览型号30151-33的Datasheet PDF文件第50页  
Processor Programming (Continued)  
Table 3-7. CR4-CR0 Bit Definitions (Continued)  
Bit  
Name Description  
30  
CD  
Cache Disable: If CD = 1, no further cache line fills occur. However, data already present in the cache continues  
to be used if the requested address hits in the cache. Writes continue to update the cache and cache invalida-  
tions due to inquiry cycles occur normally. The cache must also be invalidated with a WBINVD instruction to com-  
pletely disable any cache activity.  
29  
NW  
Not Write-Through: If NW = 1, the on-chip cache operates in write-back mode. In write-back mode, writes are  
issued to the external bus only for a cache miss, a line replacement of a modified line, execution of a locked  
instruction, or a line eviction as the result of a flush cycle. If NW = 0, the on-chip cache operates in write-through  
mode. In write-through mode, all writes (including cache hits) are issued to the external bus. This bit cannot be  
changed if LOCK_NW = 1 in CCR2.  
18  
16  
5
AM  
WP  
NE  
Alignment Check Mask: If AM = 1, the AC bit in the EFLAGS register is unmasked and allowed to enable align-  
ment check faults. Setting AM = 0 prevents AC faults from occurring.  
Write Protect: Protects read-only pages from supervisor write access. WP = 0 allows a read-only page to be  
written from privilege level 0-2. WP = 1 forces a fault on a write to a read-only page from any privilege level.  
Numerics Exception: NE = 1 to allow FPU exceptions to be handled by interrupt 16. NE = 0 if FPU exceptions  
are to be handled by external interrupts.  
4
3
RSVD Reserved: Do not attempt to modify, always 1.  
TS  
Task Switched: Set whenever a task switch operation is performed. Execution of a floating point instruction with  
TS = 1 causes a DNA fault. If MP = 1 and TS = 1, a WAIT instruction also causes a DNA fault.  
2
1
EM  
MP  
Emulate Processor Extension: If EM = 1, all floating point instructions cause a DNA fault 7.  
Monitor Processor Extension: If MP = 1 and TS = 1, a WAIT instruction causes Device Not Available (DNA)  
fault 7. The TS bit is set to 1 on task switches by the CPU. Floating point instructions are not affected by the state  
of the MP bit. The MP bit should be set to one during normal operations.  
0
PE  
Protected Mode Enable: Enables the segment based protection mechanism. If PE = 1, protected mode is  
enabled. If PE = 0, the CPU operates in real mode and addresses are formed as in an 8086-style CPU. Refer to  
Section 3.13 “Protection” on page 86.  
Table 3-8. Effects of Various Combinations of EM, TS, and MP Bits  
CR0[3:1]  
EM  
Instruction Type  
TS  
MP  
WAIT  
ESC  
0
0
1
1
0
0
1
1
0
0
0
0
1
1
1
1
0
1
0
1
0
1
0
1
Execute  
Execute  
Execute  
Fault 7  
Execute  
Execute  
Fault 7  
Fault 7  
Fault 7  
Fault 7  
Fault 7  
Fault 7  
Execute  
Execute  
Execute  
Fault 7  
www.national.com  
46  
Revision 3.1  
 复制成功!