CONDUCTIVE POLYMER ALUMINUM SOLID CAPACITORS
Radial Lead
New!
●Super low ESR, high ripple current capability
●Endurance: 2,000 to 5,000 hours at 105℃
●Rated voltage : 16 to 20Vdc
●RoHS Compliant
PSG
Downsized
PSF
●Halogen Free
◆SPECIFICATIONS
Items
Characteristics
Category
Temperature Range
-
55 to +105
℃
Rated Voltage
16 to 20Vdc
Capacitance Tolerance P20% (M)
(at 20
℃, 120Hz)
Surge Voltage
Rated voltage(V)B1.15
(at 105℃)
Leakage Current
I=0.2CV or 500μA, whichever is greater
*Note
Where, I : Leakage current (μA), C : Nominal capacitance (μF), V : Rated voltage (V)
(at 20
℃
after 2 minutes)
Dissipation Factor
(tanδ)
0.12 max.
(at 20 , 120Hz)
℃
Low Temperature
Characteristics
(Max.Impedance Ratio)
Z(
Z(
-
25
℃
)/Z(+20
℃
)
≦
1.25
1.15
-55
℃)/Z(+20℃)≦
(at 100kHz)
The following specifications shall be satisfied when the capacitors are restored to 20℃ after the rated voltage is applied for 5,000 hours
Endurance
(20V : 2,000 hours) at 105
Appearance
℃.
No significant damage
20% of the initial value
The initial specified value
150% of the initial specified value
The initial specified value
Capacitance change
D.F. (tan
ESR
Leakage current
≦±
≦
≦
≦
δ)
Bias Humidity Test The following specifications shall be satisfied when the capacitors are restored to 20
℃ after subjecting them to DC voltage at 60℃,
90 to 95% RH for 1,000 hours.
Appearance
No significant damage
20% of the initial value
The initial specified value
150% of the initial specified value
The initial specified value
Surge Voltage Test The capacitors shall be subjected to 1,000 cycles each consisting of charge with the surge voltage specified at 105
through a protective resistor(R=1 ) and discharge for 5 minutes 30 seconds.
No significant damage
20% of the initial value
The initial specified value
150% of the initial specified value
The initial specified value
0.5% per 1,000 hours maximum (Confidence level 60% at 105
Capacitance change
≦±
≦
≦
≦
D.F. (tan
ESR
Leakage current
δ
)
℃
for 30 seconds
k
Ω
Appearance
Capacitance change
≦±
≦
≦
≦
D.F. (tan
ESR
Leakage current
δ
)
Failure Rate
℃)
*Note : If any doubt arises, measure the leakage current after the following voltage treatment.
Voltage treatment : DC rated voltage is applied to the capacitors for 120 minutes at 105℃.
Product specifications in this catalog are subject to change without notice.Request our product specifications before purchase and/or use. Please use our products based on the information contained in this catalog and product specifications.
(1/2)
CAT. No. E1001L
NPC [ NIPPON PRECISION CIRCUITS INC ]
