CONDUCTIVE POLYMER ALUMINUM SOLID CAPACITORS
New!
Radial Lead
low ESR, high ripple current capability
●
Endurance: 2,000 to 5,000 hours at 105℃
●
Rated voltage : 16 to 20V
dc
●
RoHS Compliant
●
Halogen Free
●
Super
PSG
Downsized
PSF
◆SPECIFICATIONS
Items
Category
Temperature Range
Rated Voltage
Capacitance Tolerance
Surge Voltage
Leakage Current
*Note
Characteristics
-55 to +105
℃
16 to 20V
dc
P20% (M)
Rated voltage(V)B1.15
I=0.2CV or 500μA, whichever is greater
Where, I : Leakage current (μA), C : Nominal capacitance (μF), V : Rated voltage (V)
0.12 max.
Z(-25
℃
)/Z(+20
℃
)
≦
1.15
Z(-55
℃
)/Z(+20
℃
)
≦
1.25
(at 100kHz)
The following specifications shall be satisfied when the capacitors are restored to 20
℃
after the rated voltage is applied for 5,000 hours
(20V : 2,000 hours) at 105
℃
.
Appearance
No significant damage
Capacitance change
≦±
20% of the initial value
D.F. (tan
δ
)
≦
The initial specified value
ESR
≦
150% of the initial specified value
Leakage current
≦
The initial specified value
The following specifications shall be satisfied when the capacitors are restored to 20
℃
after subjecting them to DC voltage at 60
℃
,
90 to 95% RH for 1,000 hours.
Appearance
No significant damage
Capacitance change
≦±
20% of the initial value
D.F. (tan
δ
)
≦
The initial specified value
ESR
≦
150% of the initial specified value
Leakage current
≦
The initial specified value
The capacitors shall be subjected to 1,000 cycles each consisting of charge with the surge voltage specified at 105
℃
for 30 seconds
through a protective resistor(R=1kΩ) and discharge for 5 minutes 30 seconds.
Appearance
No significant damage
≦±
20% of the initial value
Capacitance change
≦
The initial specified value
D.F. (tan
δ
)
≦
150% of the initial specified value
ESR
≦
The initial specified value
Leakage current
0.5% per 1,000 hours maximum (Confidence level 60% at 105
℃
)
(at 20
℃
, 120Hz)
(at 105
℃
)
(at 20
℃
after 2 minutes)
(at 20
℃
, 120Hz)
Dissipation Factor
(tanδ
)
Low Temperature
Characteristics
(Max.Impedance Ratio)
Endurance
Bias Humidity Test
Surge Voltage Test
Failure Rate
*Note : If any doubt arises, measure the leakage current after the following voltage treatment.
Voltage treatment : DC rated voltage is applied to the capacitors for 120 minutes at 105℃.
Product specifications in this catalog are subject to change without notice.Request our product specifications before purchase and/or use. Please use our products based on the information contained in this catalog and product specifications.
(1/2)
CAT. No. E1001L