NICHIA STS-DA1-1822A <Cat.No.110630>
SOLDERING
• Recommended Reflow Soldering Condition(Lead-free Solder)
• Recommended Hand Soldering Condition
Temperature
350°C Max
3sec Max
Soldering Time
1 to 5°C per sec
Pre-heat
180 to 200°C
60sec Max
Above 220°C
120sec Max
260°C Max
10sec Max
●
Recommended Soldering Pad Pattern
1.5
0.9
1.5
0.85
(単�½� Unit: mm)
* This LED is designed to be reflow soldered on to a PCB. If dip soldered, Nichia cannot guarantee its reliability.
* Reflow soldering must not be performed more than twice. Hand soldering must not be performed more than once.
* Avoid rapid cooling. Ramp down the temperature gradually from the peak temperature.
* Nitrogen reflow soldering is recommended. Air flow soldering conditions can cause optical degradation,
caused by heat and/or atmosphere.
* Repairing should not be done after the LEDs have been soldered. When repairing is unavoidable,
a double-head soldering iron should be used.
It should be confirmed beforehand whether the characteristics of the LEDs will or will not be damaged by repairing.
* When soldering, do not apply stress to the LED while the LED is hot.
6
NICHIA [ NICHIA CORPORATION ]
