CompactRIO High-Performance Real-Time Controllers
Electromagnetic Compatibility
This product is designed to meet the requirements of the following
standards of EMC for electrical equipment for measurement, control,
and laboratory use:
• EN 61326 EMC requirements; Industrial Immunity
• EN 55011 Emissions; Group 1, Class A
• CE, C-Tick, ICES, and FCC Part 15 Emissions; Class A
Note:
For EMC compliance, operate this device according to
product documentation.
Environmental
The cRIO-901x controllers are intended for indoor use only. For outdoor
use, mount the CompactRIO system in a suitably rated enclosure.
Operating temperature ............................ -40 to 70 °C (meets IEC 60068-2-1,
IEC 60068-2-2)
Note:
To meet this operating temperature range, follow the guidelines in
the installation instructions for your CompactRIO system.
Storage temperature................................ -40 to 85 °C (meets IEC 60068-2-1,
IEC 60068-2-2)
Ingress protection ............................... IP 40
Operating humidity ............................. 10 to 90% RH, noncondensing
(meets IEC 60068-2-56)
Storage humidity................................. 5 to 95% RH, noncondensing
(meets IEC 60068-2-56)
Maximum altitude............................... 2,000 m
Pollution degree.................................. 2 (meets IEC 60664)
CE Compliance
This product meets the essential requirements of applicable European
Directives, as amended for CE marking, as follows:
• 73/23/EEC; Low-Voltage Directive (safety)
• 89/336/EEC; Electromagnetic Compatibility Directive (EMC)
Note:
Refer to the Declaration of Conformity (DoC) for this product for
any additional regulatory compliance information. To obtain the DoC for
this product, visit
ni.com/certification,
search by model number or
product line, and click the appropriate link in the Certification column.
Shock and Vibration
To meet these specifications, you must panel mount the CompactRIO
system, affix ferrules to the ends of the terminal wires, and install a tie
wrap on the USB cable for strain relief. You can use the tie wrap to attach
the USB cable to the Ethernet cable.
Operating vibration, random............... 5 g
rms
, 10 to 500 Hz
(meets IEC 60068-2-64)
Operating shock .................................. 30 g, 11 ms half sine 50 g,
3 ms half sine, 18 shocks at
6 orientations
(meets IEC 60068-2-27)
Operating vibration, sinusoidal........... 5 g, 10 to 500 Hz
(meets IEC 60068-2-6)
Waste Electrical and Electronic Equipment (WEEE)
EU Customers:
At the end of their life cycle, all products must be sent
to a WEEE recycling center. For more information about WEEE recycling
centers and National Instruments WEEE initiatives, visit
ni.com/environment/weee.htm.
Hazardous Locations
U.S. (UL) ................................................... Class I, Division 2, Groups A, B, C,
D, T4; Class I, Zone 2, AEx nA II T4
Canada (C-UL).......................................... Class I, Division 2, Groups A, B, C,
D, T4; Class I, Zone 2, Ex nA II T4
Europe (DEMKO) ................................. EEx nA II T4
BUY ONLINE
at
ni.com
or
CALL 800 813 3693 (U.S.)
3
NI [ NATIONAL INSTRUMENTS CORPORATION ]
