Portable, Modular Signal Conditioning Modules
NI SCC-AO10 Isolated Analog Output
Specifications
SCC-AO10
Output Characteristics
Number of output channels................ 1 nonreferenced single ended
Input range.......................................... ±10 V
Output range ....................................... ±10 V
Current drive ....................................... ±30 mA
Gain nonlinearity................................. 0.5ꢀ of full-scale output range
Propagation delay ............................... 10 µs
Output noise........................................ 2.5 mVrms typ; 4 mVrms max
Bandwidth........................................... >23 kHz
Model
SCC-AO10
Channel
1
Description
±10 V isolated voltage output
Part Number
777459-50
Slew rate............................................. 1 V/µs
The National Instruments SCC-AO10 is a single-channel isolated analog
voltage output module with an output range of ±10 V. Each channel of
the NI SCC-AO10 is referenced to its own isolated ground, allowing up to
±0 VDC of common-mode voltage between grounds (channel-to-channel
or channel-to-chassis). In addition, the SCC-AO10 increases the output
current drive capacity of an M Series, E Series, or B Series multifunction
DAQ device to ±30 mA. Because the modules are isolated, you can
cascade two SCC-AO10 modules for an output range of ±20 V. There is
a maximum of two SCC-AO10 modules per carrier.
Safety Isolation
Channel-to-earth
(signal + common mode) ................ ±0 VDC, CAT I
Environment
Operating temperature ....................... 0 to 50 °C
Relative humidity ................................ 10 to 90ꢀ noncondensing
Stability
Output offset temperature
coefficient................................... 300 µV/°C
Gain temperature coefficient ......... 300 ppm/°C
Note: Use the SCC-AO10 with only multifunction DAQ devices that have
Power Requirements
Analog................................................. 180 mW
Digital.................................................. 1.15 W
analog outputs.
BUY ONLINE at ni.com or CALL 800 813 3693 (U.S.)
10
NI [ National Instruments ]
