SP
Use method
Method for mounting on DIN rail
1. Both the SP relay 2c and 4c can be
mounted to the mounting slats.
2. Use the mounting slats either by attach-
ing them directly to the chassis, or by
mounting with a DIN rail.
(1) First fit the arc shaped claw of the
Fig. 1
mounting slat into the DIN rail.
(2) Press on the side as shown in the dia-
gram below.
(3) Fit in the claw part on the opposite
side.
Fit in
Mounting
slat
Press
DIN rail
(A) When attaching directly to chassis
Use two M3 screws.
Press relay in
Fig. 2
Precautions for use
For the mounting pitch, refer to the speci-
fication diagram.
(B) When mounting on a DIN rail
Use a 35mm 1.378inch wide DIN rail
(DIN46277).
When mounting to a DIN rail, use a com-
mercially available fastening bracket if
there is a need to stop sliding of the
mounting slat in the rail direction.
Fit into mounting
grooves.
Fig. 3
The mounting method should be as indi-
cated in the diagram at right.
To remove the
relay, press down
the mounting slats
so the claws move
to the outside.
For Cautions for Use, see Relay Technical Information (Page 48 to 76).
257
9/1/2000
All Rights Reserved, © Copyright Matsushita Electric Works, Ltd.
Go To Online Catalog
NAIS [ NAIS(MATSUSHITA ELECTRIC WORKS) ]
