欢迎访问ic37.com |
会员登录 免费注册
发布采购

MEV1S2415SC 参数 Datasheet PDF下载

MEV1S2415SC图片预览
型号: MEV1S2415SC
PDF下载: 下载PDF文件 查看货源
内容描述: 隔离电压3000VDC 1W单,双输出DC / DC转换器 [3kVDC Isolated 1W Single & Dual Output DC/DC Converters]
分类和应用: 转换器电源电路PC
文件页数/大小: 10 页 / 204 K
品牌: MURATA [ muRata ]
 浏览型号MEV1S2415SC的Datasheet PDF文件第1页浏览型号MEV1S2415SC的Datasheet PDF文件第2页浏览型号MEV1S2415SC的Datasheet PDF文件第3页浏览型号MEV1S2415SC的Datasheet PDF文件第4页浏览型号MEV1S2415SC的Datasheet PDF文件第6页浏览型号MEV1S2415SC的Datasheet PDF文件第7页浏览型号MEV1S2415SC的Datasheet PDF文件第8页浏览型号MEV1S2415SC的Datasheet PDF文件第9页  
MEV1 Series  
3kVDC Isolated 1W Single & Dual Output DC/DC Converters  
APPLICATION NOTES  
Minimum load  
The minimum load to meet datasheet specification is 10% of the full rated load across the specified input voltage range. Lower than 10% minimum loading will result in  
an increase in output voltage, which may rise to typically double the specified output voltage if the output load falls to less than 5%.  
Capacitive loading and start up  
Typical start up times for this series, with a typical input voltage rise time of 2.2μs and output capacitance of 10μF, are shown in the table below. The product  
series will start into a capacitance of 47μF with an increased start time, however, the maximum recommended output capacitance is 10μF.  
Start-up time  
μs  
Start-up time  
μs  
Typical Start-Up Wave Form  
MEV1x0505xC  
MEV1x0509xC  
MEV1x0512xC  
MEV1x0515xC  
MEV1x1205xC  
MEV1x1209xC  
MEV1x1212xC  
MEV1x1215xC  
MEV1x1505xC  
MEV1x1509xC  
585  
MEV1x1512xC  
MEV1x1515xC  
MEV1x2405xC  
MEV1x2409xC  
MEV1x2412xC  
MEV1x2415xC  
MEV1x4805SC  
MEV1x4809SC  
MEV1x4812SC  
MEV1x4815SC  
3045  
4445  
440  
1550  
2700  
4320  
605  
4355  
1855  
2930  
580  
1750  
3000  
4800  
660  
1320  
2075  
3235  
1720  
Ripple & Noise Characterisation Method  
Ripple and noise measurements are performed with the following test configuration.  
C1  
C2  
1μF X7R multilayer ceramic capacitor, voltage rating to be a minimum of 3 times the output voltage of the DC/DC converter  
10μF tantalum capacitor, voltage rating to be a minimum of 1.5 times the output voltage of the DC/DC converter with an ESR of less  
than 100mꢀ at 100 kHz  
C3  
R1  
100nF multilayer ceramic capacitor, general purpose  
450ꢀ resistor, carbon film, 1% tolerance  
R2  
50ꢀ BNC termination  
T1  
3T of the coax cable through a ferrite toroid  
RLOAD  
Resistive load to the maximum power rating of the DC/DC converter. Connections should be made via twisted wires  
Measured values are multiplied by 10 to obtain the specified values.  
Differential Mode Noise Test Schematic  
DC/DC Converter  
OSCILLOSCOPE  
Y INPUT  
R2  
C1 C2 C3  
R1  
T1  
+
+
Input  
Output  
SUPPLY  
-
-
R LOAD  
www.murata-ps.com  
Technical enquiries email: mk@murata-ps.com, tel: +44 (0)1908 615232  
2011-05-09 KDC_MEV1.F01 Page 5 of 10