MP1583 – 3A, 23V, 385KHz STEP-DOWN CONVERTER
TYPICAL PERFORMANCE CHARACTERISTICS
Soft-Start
SS
1.5A Resistive Load
Efficiency Curve
C
Open, V = 10V, V = 3.3V,
IN OUT
V
= 7V
IN
100
90
80
70
60
50
V
=5.0V
OUT
V
EN
5V/div.
V
=2.5V
OUT
V
OUT
2V/div.
V
=3.3V
OUT
I
L
1A/div.
0
0.5 1.0 1.5 2.0 2.5 3.0 3.5
MP1583-TPC02
LOAD CURRENT (A)
MP1583-TPC01
V
V
EN
EN
5V/div.
5V/div.
V
V
OUT
OUT
2V/div.
2V/div.
I
L
I
L
1A/div.
1A/div.
1ms/div.
MP1583-TPC03
MP1583-TPC04
PIN FUNCTIONS
Pin # Name Description
High-Side Gate Drive Bootstrap Input. BS supplies the drive for the high-side N-Channel MOSFET
switch. Connect a 4.7nF or greater capacitor from SW to BS to power the high-side switch.
Power Input. IN supplies the power to the IC. Drive IN with a 4.75V to 23V power source. Bypass
IN to GND with a suitably large capacitor to eliminate noise on the input to the IC. See Input
Capacitor
1
2
BS
IN
Power Switching Output. SW is the switching node that supplies power to the output. Connect the
output LC filter from SW to the output load. Note that a capacitor is required from SW to BS to
power the high-side switch.
3
SW
4
5
GND Ground. (Note: For the SOIC8E package, connect the exposed pad on backside to Pin 4).
Feedback Input. FB senses the output voltage and regulates it. Drive FB with a resistive voltage
FB
divider from the output voltage. The feedback threshold is 1.222V. See Setting the Output Voltage
Compensation Node. COMP is used to compensate the regulation control loop. Connect a series
COMP
6
RC network from COMP to GND to compensate the regulation control loop. See Compensation
MP1583 Rev. 3.1
6/20/2011
www.MonolithicPower.com
MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited.
© 2011 MPS. All Rights Reserved.
4
MPS [ MONOLITHIC POWER SYSTEMS ]
