EV6001DN-00D – WLED DRIVER EVALUATION BOARD
Figure 5—Evaluation Board Top Silk Layer
Figure 6—Evaluation Board Top Layer
Figure 7—Evaluation Board Bottom Silk Layer
Figure 8—Evaluation Board Bottom Layer
QUICK START GUIDE
1. Connect the LED board to the WLED driver following the pinout.
2. Preset power supply output to 7V to 21V and turn off the power supply.
3. Connect the positive terminal of the power supply output to VIN pin, and the negative terminal of
the power supply output to GND pin.
4. Turn power supply on and the board will automatically startup.
5. To use Enable function, apply a digital input to EN pin. Drive EN with 2.5V-5V to turn off the
regulator, and drive EN less than 0.7V to turn it on.
6. To use Dim function, apply a 1KHz PWM signal to DIM pin (High > 4V – 5V, Low < 0.5V).
Change the duty cycle to adjust the brightness level.
NOTICE:
The information in this document is subject to change without notice. Users should warrant and guarantee that third
party Intellectual Property rights are not infringed upon when integrating MPS products into any application. MPS will not
assume any legal responsibility for any said applications.
EV6001DN-00D Rev. 1.0
9/5/2006
www.MonolithicPower.com
MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited.
© 2006 MPS. All Rights Reserved.
6
MPS [ MONOLITHIC POWER SYSTEMS ]
