MT8980D
Line Interface Circuit
with Codec (e.g. 8964)
8
Speech
Switch
-
8980
STi0-7
Line 1
8
STo0-7
Controlling
Micro-
Processor
STo0-7
8
STi0-7
•
•
•
Repeated for Lines
2 to 255
•
•
•
Repeated for Lines
2 to 255
8
Control &
Signalling
-
8980
Line Interface Circuit
with Codec (e.g.8964)
Line 256
Figure 8 - Example Architecture of a Simple Digital Switching System
Application Circuit with 6802 Processor
Fig. 10 shows an example of a complete circuit
which may be used to evaluate the chip.
For convenience, a 4 MHz crystal oscillator has been
used rather than a 4.096 MHz clock, as both are
within the limits of the chip’s specifications. The RC
delay used with the 393 counters ensures a
sufficient hold time for the FP signal, but the values
used may have to be changed if faster 393 counters
become available.
8980
#1
IN 0/7
STi0/7 STo0/7
OUT 0/7
The chip is shown as memory mapped into the
MEK6802D3 system. Chip addresses 00-3F
correspond to processor addresses 2000-203F.
Delay through the address decoder requires the
VMA signal to be used twice to remove glitches. The
MEK6802D3 board uses a 10KΩ pullup on the MR
pin, which would have to be incorporated into the
circuit if the board was replaced by a processor.
8980
#2
STi0/7 STo0/7
OUT 8/15
8980
#3
IN 8/15
STi0/7 STo0/7
8980
#4
STi0/7 STo0/7
Figure 9 - Four 8980s Arranged in a Non-Blocking 16 x 16 Configuration
2-10