MIW2300 Series
Output Specifications
Parameter
Conditions
Min.
---
Typ.
{0.5
{0.5
{0.2
{0.3
40
Max.
{2.0
{3.0
{1.0
{1.0
75
Unit
%
Output Voltage Accuracy
Output Voltage Balance
Line Regulation
Dual Output, Balanced Loads
Vin=Min. to Max.
---
%
---
%
Load Regulation
Io=Min. to Max.
---
%
Ripple & Noise (20MHz)
Ripple & Noise (20MHz)
Ripple & Noise (20MHz)
Over Power Protection
Transient Recovery Time
Transient Response Deviation
Temperature Coefficient
Output Short Circuit
---
mV P-P
mV P-P
mV rms
%
Over Line, Load & Temp.
---
---
---
---
150
150
---
15
Vin=Min.
110
---
500
---
uS
25% Load Step Change
---
{2
---
{0.02
%
---
{0.01
%/]
Continuous
General Specifications
Parameter
Isolation Voltage Rated
Isolation Voltage Test
Isolation Resistance
Isolation Capacitance
Switching Frequency
MTBF
Conditions
60 Seconds
Min.
1500
1650
1000
---
---
1000
Typ.
---
---
---
380
Max.
---
---
---
500
Unit
VDC
VDC
M[
Flash Tested for 1 Second
500VDC
100KHz,1V
pF
350
---
---
KHz
MIL-HDBK-217F @ 25], Ground Benign
---
K Hours
Notes :
1. Specifications typical at Ta=+25], resistive load, nominal input voltage, rated output current unless otherwise noted.
2. Transient recovery time is measured to within 1% error band for a step change in output load of 75% to 100%.
3. Ripple & Noise measurement bandwidth is 0-20 MHz.
4. These power converters require a minimum output loading to maintain specified regulation.
5. Operation under no-load conditions will not damage these modules; however, they may not meet all specifications listed.
6. All DC/DC converters should be externally fused at the front end for protection.
7. Other input and output voltage may be available, please contact factory.
8. Specifications subject to change without notice.
REV:5 2008/10/02
MINMAX
3
MINMAX [ MINMAX TECHNOLOGY CO., LTD. ]
