53111
Power MOSFET Optocoupler
TYPICAL CHARACTERISTICS
All typical values are at TA = 25°C, IF (ON) = 10mA, VF (OFF) = 0.6V unless otherwise specified.
Parameter
Symbol
Test
Conditions
Typ.
Units
Notes
VO = 28 V
f = 1 MHz
IF = 10 mA
IO = 0 mA
Output Off-Capacitance
Output Offset Voltage
CO (OFF)
145
2
pF
VOS
∆VF /∆TA
CIN
6
µV
mV/°C
pF
Input Diode Temperature
Coefficient
IF = 10 mA
-1.4
20
VF = 0 V
f = 1 MHz
VI-O = 0 V
f = 1 MHz
VI-O = 500 V
t = 60 s
Input Capacitance
7
4
4
Input-Output
Capacitance
CI-O
RI-O
1.5
1013
pF
Input-Output Resistance
Ω
Notes:
1. Maximum junction to case thermal resistance for the device is 15ºC/W, where case temperature, TC, is
measured at the center of the package bottom.
2. For rating, see Figure 5. The output power PD rating curve is obtained when the part is handling the maximum
average output current IO as shown in Figure 3.
3. During the pulsed RON measurement (IO duration < 30 ms), ambient (TA) and case temperature (TC) are equal.
4. Pins 2 through 3 shorted together and pins 5 through 8 shorted together.
5. This is a momentary withstand test, not an operating condition.
6. VOS is a function of IF and is defined between pins 5 and 8, with pin 5 as the reference. VOS must be measured
in a stable ambient (free of temperature gradients).
7. Zero-bias capacitance measured between the LED anode and cathode.
CAUTION:
Care should be taken not to exceed the maximum output power dissipation, maximum case temperature, and
maximum junction temperature when repetitively switching loads.
Micropac Industries cannot assume any responsibility for any circuits shown or represent that they are free from patent infringement.
Micropac reserves the right to make changes at any time in order to improve design and to supply the best product possible.
MICROPAC INDUSTRIES, INC. MICROCS PRODUCTS DIVISION • 905 E. Walnut St., Garland, TX 75040 • (972) 272-3571 • Fax (972) 494-2281
www.micropac.com
E-MAIL: hybridsales@micropac.com
5/22/02
Pg. 4 of 11
MII [ Micropac Industries ]
