FLASH
AS29F010
Chip erase is a six-bus-cycle operation. The chip erase
command sequence is initiated by writing two unlock cycles,
followed by a set-up command. Two additional unlock write
cycles are then followed by the chip erase command, which
in turn invokes the Embedded Erase algorithm. The device
does not require the system to preprogram prior to erase. The
Embedded Erase algorithm automatically preprograms and
verifies the entire memory for an all zero data pattern prior
to electrical erase. The system is not required to provide any
controls or timings during these operations. The Command
Definitions table shows the address and data requirements for
the chip erase command sequence.
Autoselect Command Sequence
The autoselect command sequence allows the host
system to access the manufacturer and devices codes, and
determine whether or not a sector is protected. The Command
Definitions table shows the address and data requirements. This
method is an alternative to that shown in the Autoselect Codes
(High Voltage Method) table, which is intended for PROM
programmers and requires VID on address bit A9.
The auto select command sequence is initiated by writing
two unlock cycles, followed by the autoselect command. The
device then enters the autoselect mode, and the system may read
at any address any number of times, without initiating another
command sequence.
Any commands written to the chip during the Embedded
Erase algorithm are ignored.
The system can determine the status of the erase
op-
Aread cycle at address XX00h or retrieves the
manu-
eration by using DQ7 or DQ6. See “Write Operation Status”
for information on these status bits. When the Embedded Erase
algorithm is complete, the device returns to reading array data
and addresses are no longer latched.
Figure 2 illustrates the algorithm for the erase op-
eration. See the Erase/Program Operations tables in “AC
Characteristics” for parameters, and the Chip /Sector Erase
facturer code. Aread cycle at address XX01h returns the device
code. A read cycle containing a sector address (SA) and the
address 02h in returns 01h if that sector is protected, or 00h if
it is unprotected. Refer to the Sector Address tables for valid
sector addresses.
The system must write the reset command to exit the au-
toselect mode and return to reading array data.
FIGURE 1: PROGRAM OPERATION
Byte Program Command Sequence
Programming is a four-bus-cycle operation. The pro-
gram command sequence is initiated by writing two unlock
write cycles, followed by the program set-up command. The
program address and data are written next, which in turn initiate
the Embedded Program algorithm. The system is not required
to provide further controls or timings. The device
au-
tomatically provides internally generated program pulses and
verify the programmed cell margin. The Command Definitions
take shows the address and data requirements for the byte pro-
gram command sequence.
When the Embedded Program algorithm is complete, the
device then returns to reading array data and addresses are no
longer latched. The system can determine the status of the
program operation by using DQ7 or DQ6. See “Write Opera-
tion Status” for information on these status bits.
Any commands written to the device during the
bedded Program Algorithm are ignored.
Em-
Programming is allowed in any sequence and across sec-
tor boundaries. A bit cannot be programmed from a “0” back
to a “1”. Attempting to do so may halt the operation and set
DQ5 to “1”, or cause the Data\ Polling algorithm to indicate
the operation was successful. However, a succeeding read
will show that the data is still “0”. Only erase operations can
convert a “0” to a “1”.
NOTE: See the appropriate Command Definitions table for program com-
mand sequence.
Chip Erase Command Sequence
AS29F010
Micross Components reserves the right to change products or specifications without notice.
Rev. 2.6 11/10
7
MICROSS [ MICROSS COMPONENTS ]
