AS1419
AS1419A
NOTES:
ADC
1. Absolute Maximum Ratings are those values beyond which
the life of a device may be impaired.
2. All voltage values are with respect to ground with DGND
and AGND wired together unless otherwise noted.
3. When these pin voltages are taken below V
SS
or above V
DD
,
they will be clamped by internal diodes. This product can
handle input currents greater than 100mA below V
SS
or above
V
DD
without latchup.
4. When these pin voltages are taken below V
SS
, they will be
clamped by internal diodes. This product can handle input
currents greater than 100mA below V
SS
without latchup. These
pins are not clamped to V
DD
.
5. V
DD
= 5V, V
SS
= –5V, f
SAMPLE
= 800kHz, t
r
= t
f
= 5ns unless
otherwise specified.
6. Linearity, offset and full-scale specifications apply for a
single ended +A
IN
input with – A
IN
grounded.
7. Integral nonlinearity is defined as the deviation of a code
from a straight line passing through the actual endpoints of the
transfer curve. The deviation is measured from the center of
the quantization band.
8. Bipolar offset is the offset voltage measured from –0.5LSB
when the output code
fl
ickers between 0000 0000 0000 00 and
1111 1111 1111 11.
9. Guaranteed by design, not subject to test.
10. Recommended operating conditions.
11. The falling edge of CONVST\ starts a conversion. If CON-
VST\ returns high at a critical point during the conversion it can
create small errors. For best performance ensure that CONVST\
returns high either within 650ns after the start of the conversion
or after BUSY\ rises.
FUNCTIONAL BLOCK DIAGRAM
AS1419 & AS1419A
Rev. 1.7 06/10
Micross Components reserves the right to change products or specifications without notice.
5