SRAM
AS8S128K32
NOTES
1. All voltages referenced to VSS (GND).
2. -3v for pulse width <20ns.
7. At any given temperature and voltage condition,
tHZCE, is less than tLZCE, and tHZWE is less than tLZWE
.
3. ICC is dependent on output loading and cycle rates.
The specified value applies with the outputs
8. ?W/E is HIGH for READ cycle.
9. Device is continuously selected. Chip enables and output
enable are held in their active state.
10. Address valid prior to or coincident with latest occurring
chip enable.
11. tRC= READ cycle time.
12. Chip enable (?C/E) and write enable (?W/E) can initiate
and terminate a WRITE cycle.
1
open, and f=
HZ.
tRC(MIN)
4. This parameter is sampled.
5. Test conditions as specified with output loading as
shown in Fig. 1 unless otherwise noted.
6. tHZCE, tHZOE and tHZWE are specified with CL= 5pF
as in Fig. 2. Transition is measured +/- 200 mV
typical from steady state coltage, allowing for actual
tester RC time constant.
13. 32 bit operation
DESCRIPTION
CONDITIONS
SYMBOL
MIN
MAX
UNITS
NOTES
VCC for Retention Data
VDR
2
--
V
CE\ > VCC - 0.2V
VIN > VCC - 0.2V
VCC = 2.0V
VCC = 3V
ICCDR
ICCDR
--
--
10
12
mA
mA
Data Retention Current
Chip Deselect to Data
Retention Time
tCDR
tR
0
--
ns
ns
4
tRC
4, 11
Operation Recovery Time
LOW VCC DATA RETENTION WAVEFORM
DATA RETENTION MODE
>2V
VDR
VDR
4.5V
4.5V
Vcc
tCDR
tR
VIH
CE\
V
IL
Micross Components reserves the right to change products or specifications without notice.
AS8S128K32
Rev. 4.5 08/13
5