TABLE II. Electrical test requirements.
Subgroups
Test requirements
Subgroups
(in accordance with
MIL-STD-883,
(in accordance with
MIL-PRF-38535, table III)
method 5005, table I)
Device
class M
Device
class Q
Device
class V
Interim electrical
----
----
----
parameters (see 4.2)
Final electrical
parameters (see 4.2)
1,2,3,4, 1/
5,6,7
1,2,3,4,
5,6,7
1/
1,2,3,4,
5,6,7
1/
Group A test
1,2,3,4,5,6,7
1,2,3,4,5,6,7
1,2,3,4,5,6,7
requirements (see 4.4)
Group C end-point electrical
parameters (see 4.4)
1
1
1,2,3,4,5,6,7
Group D end-point electrical
parameters (see 4.4)
1
1
1
Group E end-point electrical
parameters (see 4.4)
---
---
---
1/ PDA applies to subgroup 1.
4.4.4 Group E inspection. Group E inspection is required only for parts intended to be marked as radiation hardness assured
(see 3.5 herein).
a. End-point electrical parameters shall be as specified in table II herein.
b. For device classes Q and V, the devices or test vehicle shall be subjected to radiation hardness assured tests as
specified in MIL-PRF-38535 for the RHA level being tested. For device class M, the devices shall be subjected to
radiation hardness assured tests as specified in MIL-PRF-38535, appendix A for the RHA level being tested. All device
classes must meet the post irradiation end-point electrical parameter limits as defined in table I at
TA = +25°C ±5°C, after exposure, to the subgroups specified in table II herein.
5. PACKAGING
5.1 Packaging requirements. The requirements for packaging shall be in accordance with MIL-PRF-38535 for device classes
Q and V or MIL-PRF-38535, appendix A for device class M.
6. NOTES
6.1 Intended use. Microcircuits conforming to this drawing are intended for use for Government microcircuit applications
(original equipment), design applications, and logistics purposes.
6.1.1 Replaceability. Microcircuits covered by this drawing will replace the same generic device covered by a contractor
prepared specification or drawing.
6.1.2 Substitutability. Device class Q devices will replace device class M devices.
6.2 Configuration control of SMD's. All proposed changes to existing SMD's will be coordinated with the users of record for
the individual documents. This coordination will be accomplished using DD Form 1692, Engineering Change Proposal.
SIZE
STANDARD
MICROCIRCUIT DRAWING
5962-90842
A
DEFENSE SUPPLY CENTER COLUMBUS
COLUMBUS, OHIO 43218-3990
REVISION LEVEL
C
SHEET
10
DSCC FORM 2234
APR 97
MICROSS [ MICROSS COMPONENTS ]
