MAS 35x9F
DATA SHEET
2.11.3. Reset Signal Specification
After power-up, a reset signal should be applied to the pin POR by the microcontroller as follows:
V
2.2 V min.
DD
V
DD
POR 2.2 V min.
POR
see Note 1
2
I C access works without
0.5 µs min. delay
additional delay from this point
time
Fig. 2–14: Reset signal at pin POR
Note: The slew rate of POR should be as high as pos-
sible, but must be glitch-free in any case.
Slew rate typ.: 1 µs for 10% to 90% level transition,
Slew rate max.: 20 µs for 10% to 90% level transition.
20
June 30, 2004; 6251-505-1DS
Micronas