HAL55x, HAL56x
DATA SHEET
Two-Wire Hall-Effect Sensor Family Sensor Family
in CMOS technology
– ideal sensor for applications in extreme automotive
and industrial environments
– EMC corresponding to ISO 7637
Release Note: Revision bars indicate significant
changes to the previous edition.
1.2. Family Overview
1. Introduction
The types differ according to the mode of switching
and the magnetic switching points.
This sensor family consists of different two-wire Hall
switches produced in CMOS technology. All sensors
change the current consumption depending on the
external magnetic field and require only two wires
between sensor and evaluation circuit. The sensors of
this family differ in the magnetic switching behavior
and switching points.
Type
Switching
Behavior
Sensitivity
see
Page
556
560
unipolar
very high
low
18
20
unipolar
inverted
The sensors include a temperature-compensated Hall
plate with active offset compensation, a comparator,
and a current source. The comparator compares the
actual magnetic flux through the Hall plate (Hall volt-
age) with the fixed reference values (switching points).
Accordingly, the current source is switched on (high
current consumption) or off (low current consumption).
566
unipolar
inverted
very high
22
Unipolar Switching Sensors:
The active offset compensation leads to constant mag-
netic characteristics in the full supply voltage and tem-
perature range. In addition, the magnetic parameters
are robust against mechanical stress effects.
The sensor turns to high current consumption with the
magnetic south pole on the branded side of the pack-
age and turns to low consumption if the magnetic field
is removed. The sensor does not respond to the mag-
netic north pole on the branded side.
The sensors are designed for industrial and automo-
tive applications and operate with supply voltages from
4 V to 24 V in the junction temperature range from
−40 °C up to 140 °C. All sensors are available in the
SMD-package SOT89B-1 and in the leaded versions
TO92UA-1 and TO92UA-2.
Unipolar Inverted Switching Sensors:
The sensor turns to low current consumption with the
magnetic south pole on the branded side of the pack-
age and turns to high consumption if the magnetic field
is removed. The sensor does not respond to the mag-
netic north pole on the branded side.
1.1. Features
– current output for two-wire applications
– junction temperature range from −40 °C up to
140 °C.
– operates from 4 V to 24 V supply voltage
– operates with static magnetic fields and dynamic
magnetic fields up to 10 kHz
– switching offset compensation at typically 145 kHz
– overvoltage and reverse-voltage protection
– magnetic characteristics are robust against
mechanical stress effects
– constant magnetic switching points over a wide sup-
ply voltage range
– the decrease of magnetic flux density caused by ris-
ing temperature in the sensor system is compen-
sated by a built-in negative temperature coefficient
of the magnetic characteristics
4
Aug. 11, 2009; 000026_004ENDSH
Micronas
MICRONAS [ MICRONAS ]
