8GB (x72, ECC, DR) 240-Pin DDR3 VLP RDIMM
Electrical Specifications
Electrical Specifications
Stresses greater than those listed may cause permanent damage to the module. This is a
stress rating only, and functional operation of the module at these or any other condi-
tions outside those indicated in each device's data sheet is not implied. Exposure to ab-
solute maximum rating conditions for extended periods may adversely affect reliability.
Table 8: Absolute Maximum Ratings
Symbol
VDD
Parameter
Min
–0.4
–0.4
Max
1.975
1.975
Units
VDD supply voltage relative to VSS
Voltage on any pin relative to VSS
V
V
VIN, VOUT
Table 9: Operating Conditions
Symbol Parameter
Min
1.425
–600
Nom
1.5
–
Max
1.575
600
Units Notes
VDD
IVTT
VDD supply voltage
V
Termination reference current from
VTT
mA
VTT
II
Termination reference voltage (DC) –
command/address bus
0.49 × VDD - 20mV
–
0.5 × VDD 0.51 × VDD + 20mV
V
1
5
Input leakage current; Address in-
–
–
µA
Any input 0V ≤ VIN
≤
puts, RAS#,
VDD; VREF input 0V ≤ VIN CAS#, WE#,
≤ 0.95V (All other pins S#, CKE, ODT,
not under test = 0V)
BA, CK, CK#
DM
–4
0
0
4
IOZ
Output leakage current; DQ, DQS,
–10
10
µA
µA
0V ≤ VOUT ≤ VDD; DQ
and ODT are disabled;
ODT is HIGH
DQS#
IVREF
VREF supply leakage current;
–18
0
18
VREFDQ = VDD/2 or VREFCA = VDD/2
(All other pins not under test = 0V)
TA
TC
Module ambient
operating temperature
Commercial
0
0
–
–
70
95
°C
°C
2, 3
DDR3 SDRAM compo-
nent case operating
temperature
Commercial
2, 3, 4
1. VTT termination voltage in excess of the stated limit will adversely affect the command
and address signals’ voltage margin and will reduce timing margins.
Notes:
2. TA and TC are simultaneous requirements.
3. For further information, refer to technical note TN-00-08: “Thermal Applications,”
available on Micron’s Web site.
4. The refresh rate is required to double when 85°C < TC ≤ 95°C.
5. Inputs are terminated to VDD/2. Input current is dependent on terminating resistance se-
lected in register.
PDF: 09005aef8482a8a7
jdf18c1gx72pdz.pdf – Rev. D 12/12 EN
Micron Technology, Inc. reserves the right to change products or specifications without notice.
12
© 2011 Micron Technology, Inc. All rights reserved.