128Mb 3V Embedded Parallel NOR Flash
Device Protection
Nonvolatile protection bits and volatile protection bits have the same function when
VPP/WP# is HIGH or when VPP/WP# is at the voltage for program acceleration (VPPH ).
Password Protection Mode
Password protection mode provides a higher level of security than the nonvolatile pro-
tection mode by requiring a 64-bit password to unlock the nonvolatile protection bit
lock bit. In addition to this password requirement, the nonvolatile protection bit lock
bit is set to 0 after power-up and reset to maintain the device in password protection
mode.
Executing the UNLOCK PASSWORD command by entering the correct password clears
the nonvolatile protection bit lock bit, enabling the block nonvolatile protection bits to
be modified. If the password provided is incorrect, the nonvolatile protection bit lock
bit remains locked, and the state of the nonvolatile protection bits cannot be modified.
To place the device in password protection mode, the following two steps are required:
First, before activating the password protection mode, a 64-bit password must be set
and the setting verified. Password verification is allowed only before the password pro-
tection mode is activated. Next, password protection mode is activated by program-
ming the password protection mode lock bit to 0. This operation is irreversible. After the
bit is programmed, it cannot be erased, the device remains permanently in password
protection mode, and the 64-bit password can be neither retrieved nor reprogrammed.
In addition, all commands to the address where the password is stored are disabled.
Note: There is no means to verify the password after password protection mode is ena-
bled. If the password is lost after enabling the password protection mode, there is no
way to clear the nonvolatile protection bit lock bit.
Figure 11: Software Protection Scheme
Volatile protection bit
Nonvolatile protection bit
1 = unprotected (default)
1 = unprotected
0 = protected
0 = protected
(Default setting depends on the product order option)
Volatile
protection
Nonvolatile
protection
Nonvolatile protection bit lock bit (volatile)
Array block
1 = unlocked (default, after power-up or hardware reset)
0 = locked
Nonvolatile protection
mode
Password protection
mode
1. Volatile protection bits are programmed and cleared individually. Nonvolatile protection
bits are programmed individually and cleared collectively.
Notes:
2. Once programmed to 0, the nonvolatile protection bit lock bit can be reset to 1 only by
taking the device through a power-up or hardware reset.
PDF: 09005aef84daa141
m29w_128mb.pdf - Rev. A 7/13 EN
Micron Technology, Inc. reserves the right to change products or specifications without notice.
48
© 2012 Micron Technology, Inc. All rights reserved.
MICRON [ MICRON TECHNOLOGY ]
