Micron M25P40 Serial Flash Embedded Memory
Revision History
• Table: ICC3 Operating Current (READ) change on test condition section as follows:
OLD: C = 0.1VCC / 0.9VCC at 25 MHz, Q = open; NEW: C = 0.1VCC / 0.9VCC at 25 MHz
and 75 MHz, Q = open; OLD: C = 0.1VCC / 0.9VCC at 20 MHz, Q = open; NEW: C =
0.1VCC / 0.9VCC at 20 MHz and 33 MHz, Q = open.
• Table 15: Valid also for grade 3: OLD: Instruction times, process technology 110nm
(device grade 6); NEW: Instruction times, process technology 110nm.
• Table 16: Valid also for grade 3: OLD: Instruction times, process technology 150nm
(device grade 6); NEW: Instruction times, process technology 150nm.
• Table 17: Deleted.
• Table 19: Added the following to the table head: "Identified with device belonging to X
technology version;” changed tRES1 = 30us and tRES2 = 30us (removed 3us and 1.8us
and note 5).
Rev. 16.0 – 10/2008
• Changed frequency up to 75 MHz (only in the standard VCC range).
• Added new packages.
• Added UID/CFD protection.
• Extended VCC range to 2.3V.
Rev. 15.0 – 12/2007
Rev. 14.0 – 06/2007
• Applied Numonyx branding.
• Modified the note below Table 13.
• Changed test condition for ICC3 in Table 14.
• Changed clock frequency, from 20 to 25 MHz, in Table 20 and Table 21.
Rev. 13.0 – 05/2007
• 40 MHz operation added (see Table: AC Characteristics (*40 MHz operation, device
grade 6, VCCmin = 2.3V.)
• Removed the note below Table 10.
• Removed Table: AC Characteristics (33 MHz operation, device grade 6, VCCmin
=2.3V).
n
Rev. 12.0 – 01/2007
Rev. 11.0 – 12/2006
• VCC voltage range from W17 2007 is extended to 2.3V to 3.6V.
• Added Table: AC Characteristics (33 MHz operation, device grade 6, VCCmin =2.3V).
• AC characteristics at 40 MHz removed.
• Hardware write protection feature added to cover; small text changes to cover.
• Added sections on VCC supply voltage and VSS ground.
• Revised Figure: Bus Master and Memory Devices on the SPI Bus.
• WIP bit behavior specified at power-up in Power-Up and Power-Down section.
• Revised Table: Absolute Maximum Ratings and VIO Maximum.
PDF: 09005aef8456654f
m25p40.pdf - Rev. Y 8/12 EN
Micron Technology, Inc. reserves the right to change products or specifications without notice.
57
© 2011 Micron Technology, Inc. All rights reserved.