PIC18F45J10 FAMILY
9.2
PIR Registers
Note 1: Interrupt flag bits are set when an interrupt
condition occurs regardless of the state of
its corresponding enable bit or the Global
Interrupt Enable bit, GIE (INTCON<7>).
The PIR registers contain the individual flag bits for the
peripheral interrupts. Due to the number of peripheral
interrupt sources, there are three Peripheral Interrupt
Request (Flag) registers (PIR1, PIR2, PIR3).
2: User software should ensure the
appropriate interrupt flag bits are cleared
prior to enabling an interrupt and after
servicing that interrupt.
REGISTER 9-4:
PIR1: PERIPHERAL INTERRUPT REQUEST (FLAG) REGISTER 1
R/W-0
PSPIF(1)
bit 7
R/W-0
ADIF
R-0
R-0
R/W-0
R/W-0
R/W-0
R/W-0
RCIF
TXIF
SSP1IF
CCP1IF
TMR2IF
TMR1IF
bit 0
Legend:
R = Readable bit
-n = Value at POR
W = Writable bit
‘1’ = Bit is set
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared x = Bit is unknown
bit 7
bit 6
bit 5
bit 4
bit 3
bit 2
PSPIF: Parallel Slave Port Read/Write Interrupt Flag bit(1)
1= A read or a write operation has taken place (must be cleared in software)
0= No read or write has occurred
ADIF: A/D Converter Interrupt Flag bit
1= An A/D conversion completed (must be cleared in software)
0= The A/D conversion is not complete
RCIF: EUSART Receive Interrupt Flag bit
1= The EUSART receive buffer, RCREG, is full (cleared when RCREG is read)
0= The EUSART receive buffer is empty
TXIF: EUSART Transmit Interrupt Flag bit
1= The EUSART transmit buffer, TXREG, is empty (cleared when TXREG is written)
0= The EUSART transmit buffer is full
SSP1IF: Master Synchronous Serial Port 1 Interrupt Flag bit
1= The transmission/reception is complete (must be cleared in software)
0= Waiting to transmit/receive
CCP1IF: ECCP1/CCP1 Interrupt Flag bit
Capture mode:
1= A TMR1 register capture occurred (must be cleared in software)
0= No TMR1 register capture occurred
Compare mode:
1= A TMR1 register compare match occurred (must be cleared in software)
0= No TMR1 register compare match occurred
PWM mode:
Unused in this mode.
bit 1
bit 0
TMR2IF: TMR2 to PR2 Match Interrupt Flag bit
1= TMR2 to PR2 match occurred (must be cleared in software)
0= No TMR2 to PR2 match occurred
TMR1IF: TMR1 Overflow Interrupt Flag bit
1= TMR1 register overflowed (must be cleared in software)
0= TMR1 register did not overflow
Note 1: This bit is not implemented on 28-pin devices and should be read as ‘0’.
DS39682E-page 88
© 2009 Microchip Technology Inc.
MICROCHIP [ MICROCHIP ]
