PIC18FXX20
26.2 DC Characteristics: Power-down and Supply Current
PIC18FXX20 (Industrial, Extended)
PIC18LFXX20 (Industrial) (Continued)
PIC18LFXX20
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C ≤ TA ≤ +85°C for industrial
(Industrial)
Standard Operating Conditions (unless otherwise stated)
PIC18FXX20
Operating temperature
-40°C ≤ TA ≤ +85°C for industrial
-40°C ≤ TA ≤ +125°C for extended
(Industrial, Extended)
Param
No.
Device
Typ
Max Units
Conditions
(2,3)
Supply Current (IDD)
PIC18FX620, 9.3
15
15
mA
mA
mA
mA
mA
mA
mA
mA
mA
mA
mA
mA
µA
µA
µA
µA
µA
µA
µA
µA
µA
-40°C
PIC18FX720
9.5
25°C
85°C
-40°C
25°C
85°C
-40°C
25°C
85°C
-40°C
25°C
85°C
-10°C
25°C
70°C
-10°C
25°C
70°C
-10°C
25°C
70°C
VDD = 4.2V
VDD = 5.0V
VDD = 4.2V
10
15
FOSC = 25 MHZ,
EC oscillator
PIC18FX620, 11.8
PIC18FX720
12
20
20
12
20
PIC18FX520 TBD
TBD
TBD
TBD
TBD
TBD
TBD
TBD
TBD
TBD
TBD
TBD
TBD
TBD
TBD
TBD
TBD
TBD
FOSC = 40 MHZ,
EC oscillator
PIC18FX520 TBD
TBD
VDD = 5.0V
VDD = 2.0V
VDD = 3.0V
VDD = 5.0V
TBD
PIC18LFXX20 TBD
TBD
TBD
PIC18LFXX20 TBD
FOSC = 32 kHz,
Timer1 as clock
TBD
TBD
All devices TBD
TBD
TBD
Legend: Shading of rows is to assist in readability of the table.
Note 1: The power-down current in SLEEP mode does not depend on the oscillator type. Power-down current is measured with
the part in SLEEP mode, with all I/O pins in high-impedance state and tied to VDD or VSS, and all features that add delta
current disabled (such as WDT, Timer1 Oscillator, BOR, etc.).
2: The supply current is mainly a function of operating voltage, frequency and mode. Other factors, such as I/O pin loading
and switching rate, oscillator type and circuit, internal code execution pattern and temperature, also have an impact on the
current consumption.
The test conditions for all IDD measurements in active Operation mode are:
OSC1 = external square wave, from rail-to-rail; all I/O pins tri-stated, pulled to VDD;
MCLR = VDD; WDT enabled/disabled as specified.
3: For RC oscillator configurations, current through REXT is not included. The current through the resistor can be estimated
by the formula Ir = VDD/2REXT (mA) with REXT in kΩ.
2003 Microchip Technology Inc.
Advance Information
DS39609A-page 313
MICROCHIP [ MICROCHIP ]
