PIC18F2220/2320/4220/4320
15.4.2
TIMER1/TIMER3 MODE SELECTION
15.4 Compare Mode
Timer1 and/or Timer3 must be running in Timer mode,
or Synchronized Counter mode, if the CCP module is
using the compare feature. In Asynchronous Counter
mode, the compare operation may not work.
In Compare mode, the 16-bit CCPR1 (CCPR2) register
value is constantly compared against either the
TMR1 register pair value, or the TMR3 register pair
value. When a match occurs, the RC2/CCP1/P1A
(RC1/T1OSI/CCP2) pin:
15.4.3
SOFTWARE INTERRUPT MODE
• Is driven High
When generate software interrupt is chosen, the CCP1
pin is not affected. Only a CCP interrupt is generated (if
enabled).
• Is driven Low
• Toggles output (High to Low or Low to High)
• Remains unchanged (interrupt only)
15.4.4
SPECIAL EVENT TRIGGER
The action on the pin is based on the value of control
bits, CCP1M3:CCP1M0 (CCP2M3:CCP2M0). At the
same time, interrupt flag bit, CCP1IF (CCP2IF), is set.
In this mode, an internal hardware trigger is generated
which may be used to initiate an action.
The special event trigger output of CCP1 resets the
TMR1 register pair. This allows the CCPR1 register to
effectively be a 16-bit programmable period register for
Timer1.
15.4.1
CCP PIN CONFIGURATION
The user must configure the CCPx pin as an output by
clearing the appropriate TRISC bit.
The special trigger output of CCP2 resets either the
TMR1 or TMR3 register pair. Additionally, the CCP2
special event trigger will start an A/D conversion if the
A/D module is enabled.
Note:
Clearing the CCP1CON register will force
the RC2/CCP1/P1A compare output latch
to the default low level. This is not the
PORTC I/O data latch.
Note:
The special event trigger from the CCP2
module will not set the Timer1 or Timer3
interrupt flag bits.
FIGURE 15-2:
COMPARE MODE OPERATION BLOCK DIAGRAM
Special Event Trigger will:
Reset Timer1 or Timer3 but not set Timer1 or Timer3 interrupt flag bit
and set bit GO/DONE (ADCON0<2>) which starts an A/D conversion (CCP2 only)
Special Event Trigger
Set Flag bit CCP1IF
CCPR1H CCPR1L
Comparator
Q
S
R
Output
Logic
Match
RC2/CCP1/P1A
pin
TRISC<2>
Output Enable
1
0
CCP1CON<3:0>
Mode Select
T3CCP2
TMR1H TMR1L
TMR3H TMR3L
Special Event Trigger
Set Flag bit CCP2IF
T3CCP1
T3CCP2
0
1
Q
S
R
Output
Logic
Comparator
Match
RC1/T1OSI/CCP2
pin
TRISC<1>
Output Enable
CCPR2H CCPR2L
CCP2CON<3:0>
Mode Select
DS39599C-page 136
2003 Microchip Technology Inc.