PIC18F2220/2320/4220/4320
9.4
IPR Registers
The IPR registers contain the individual priority bits for
the peripheral interrupts. Due to the number of periph-
eral interrupt sources, there are two Peripheral Inter-
rupt Priority registers (IPR1, IPR2). Using the priority
bits requires that the Interrupt Priority Enable (IPEN) bit
be set.
REGISTER 9-8:
IPR1: PERIPHERAL INTERRUPT PRIORITY REGISTER 1
R/W-1
PSPIP(1)
bit 7
R/W-1
ADIP
R/W-1
RCIP
R/W-1
TXIP
R/W-1
SSPIP
R/W-1
R/W-1
R/W-1
TMR1IP
bit 0
CCP1IP
TMR2IP
bit 7
PSPIP(1): Parallel Slave Port Read/Write Interrupt Priority bit
1= High priority
0= Low priority
Note 1: This bit is reserved on PIC18F2X20 devices; always maintain this bit set.
bit 6
bit 5
bit 4
bit 3
bit 2
bit 1
bit 0
ADIP: A/D Converter Interrupt Priority bit
1= High priority
0= Low priority
RCIP: USART Receive Interrupt Priority bit
1= High priority
0= Low priority
TXIP: USART Transmit Interrupt Priority bit
1= High priority
0= Low priority
SSPIP: Master Synchronous Serial Port Interrupt Priority bit
1= High priority
0= Low priority
CCP1IP: CCP1 Interrupt Priority bit
1= High priority
0= Low priority
TMR2IP: TMR2 to PR2 Match Interrupt Priority bit
1= High priority
0= Low priority
TMR1IP: TMR1 Overflow Interrupt Priority bit
1= High priority
0= Low priority
Legend:
R = Readable bit
W = Writable bit
‘1’ = Bit is set
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared x = Bit is unknown
- n = Value at POR
DS39599C-page 96
2003 Microchip Technology Inc.
MICROCHIP [ MICROCHIP ]
