PIC16F785
20-Pin Flash-Based 8-Bit CMOS Microcontroller
High-Performance RISC CPU:
• Only 35 instructions to learn:
- All single-cycle instructions except branches
• Operating speed:
- DC – 20 MHz oscillator/clock input
- DC – 200 ns instruction cycle
• Interrupt capability
• 8-level deep hardware stack
• Direct, Indirect and Relative Addressing modes
Peripheral Features:
• High-speed Comparator module with:
- Two independent analog comparators
- Programmable on-chip voltage reference
(CV
REF
) module (% of V
DD
)
- 1.2V band gap voltage reference
- Comparator inputs and outputs externally
accessible
- < 40 ns propagation delay
- 2 mv offset, typical
• Operational Amplifier module with 2 independent
op amps:
- 3 MHz GBWP, typical
- All I/O pins externally accessible
• Two-Phase Asynchronous Feedback PWM
module:
- Complementary output with programmable
dead band delay
- Infinite resolution analog duty cycle
- Sync Output/Input for multi-phase PWM
- F
OSC
/2 maximum PWM frequency
• A/D Converter:
- 10-bit resolution and 14 channels (2 internal)
• 17 I/O pins and 1 input-only pin:
- High-current source/sink for direct LED drive
- Interrupt-on-pin change
- Individually programmable weak pull-ups
• Timer0: 8-bit timer/counter with 8-bit
programmable prescaler
• Enhanced Timer1:
- 16-bit timer/counter with prescaler
- External gate Input mode
- Option to use OSC1 and OSC2 in LP mode
as Timer1 oscillator, if INTOSC mode
selected
• Timer2: 8-bit timer/counter with 8-bit period
register, prescaler and postscaler
• Capture, Compare, PWM module:
- 16-bit Capture, max resolution 12.5 ns
- Compare, max resolution 200 ns
- 10-bit PWM with 1 output channel, max
frequency 20 kHz
• In-Circuit Serial Programming
TM
(ICSP
TM
) via two
pins
Special Microcontroller Features:
• Precision Internal Oscillator:
- Factory calibrated to ±1%
- Software selectable frequency range of
8 MHz to 32 kHz
- Software tunable
- Two-Speed Start-up mode
- Crystal fail detect for critical applications
- Clock mode switching during operation for
power savings
• Power-saving Sleep mode
• Wide operating voltage range (2.0V-5.5V)
• Industrial and Extended temperature range
• Power-on Reset (POR)
• Power-up Timer (PWRT) and Oscillator Start-up
Timer (OST)
• Brown-out Reset (BOR) with software control
option
• Enhanced Low-Current Watchdog Timer (WDT)
with on-chip oscillator (software selectable
nominal 268 seconds with full prescaler) with
software enable
• Multiplexed Master Clear with pull-up/input pin
• Programmable code protection
• High-Endurance Flash/EEPROM cell:
- 100,000 write Flash endurance
- 1,000,000 write EEPROM endurance
- Flash/Data EEPROM retention: > 40 years
Low-Power Features:
• Standby Current:
- 30 nA @ 2.0V, typical
• Operating Current:
- 8.5
μA
@ 32 kHz, 2.0V, typical
- 100
μA
@ 1 MHz, 2.0V, typical
• Watchdog Timer Current:
- 1
μA
@ 2.0V, typical
• Timer1 Oscillator Current:
- 2
μA
@ 32 kHz, 2.0V, typical
©
2005 Microchip Technology Inc.
Preliminary
DS41249B-page 1
MICROCHIP [ MICROCHIP TECHNOLOGY ]
