PIC16F631/677/685/687/689/690
8.10.3
OUTPUT CLAMPED TO VSS
8.10 Comparator Voltage Reference
The CVREF output voltage can be set to VSS with no
power consumption by configuring VRCON as follows:
The comparator voltage reference module provides an
internally generated voltage reference for the compara-
tors. The following features are available:
• VREN = 0
• VRR = 1
• Independent from Comparator operation
• Two 16-level voltage ranges
• Output clamped to VSS
• VR<3:0> = 0000
This allows the comparator to detect a zero-crossing
while not consuming additional CVREF module current.
• Ratiometric with VDD
• Fixed Reference (0.6)
8.10.4
OUTPUT RATIOMETRIC TO VDD
The VRCON register (Register 8-5) controls the
Voltage Reference module shown in Figure 8-8.
The comparator voltage reference is VDD derived and
therefore, the CVREF output changes with fluctuations in
VDD. The tested absolute accuracy of the Comparator
Voltage Reference can be found in Section 17.0
“Electrical Specifications”.
8.10.1
INDEPENDENT OPERATION
The comparator voltage reference is independent of
the comparator configuration. Setting the VREN bit of
the VRCON register will enable the voltage reference.
8.10.2
OUTPUT VOLTAGE SELECTION
The CVREF voltage reference has 2 ranges with 16
voltage levels in each range. Range selection is
controlled by the VRR bit of the VRCON register. The
16 levels are set with the VR<3:0> bits of the VRCON
register.
The CVREF output voltage is determined by the following
equations:
EQUATION 8-1:
CVREF OUTPUT VOLTAGE
VRR = 1 (low range):
CVREF = (VR<3:0>/24) × VDD
VRR = 0 (high range):
CVREF = (VDD/4) +
(VR<3:0> × VDD/32)
The full range of VSS to VDD cannot be realized due to
the construction of the module. See Figure 8-8.
DS41262D-page 104
© 2007 Microchip Technology Inc.