PIC16F688
14-Pin Flash-Based, 8-Bit CMOS Microcontrollers with nanoWatt Technology
High-Performance RISC CPU:
Low-Power Features:
• Only 35 instructions to learn:
- All single-cycle instructions except branches
• Operating speed:
• Standby Current:
- 50 nA @ 2.0V, typical
• Operating Current:
- DC – 20 MHz oscillator/clock input
- DC – 200 ns instruction cycle
- 11 μA @ 32 kHz, 2.0V, typical
- 220 μA @ 4 MHz, 2.0V, typical
• Watchdog Timer Current:
- 1 μA @ 2.0V, typical
• Interrupt capability
• 8-level deep hardware stack
• Direct, Indirect and Relative Addressing modes
Peripheral Features:
Special Microcontroller Features:
• 12 I/O pins with individual direction control:
- High-current source/sink for direct LED drive
- Interrupt-on-change pin
• Precision Internal Oscillator:
- Factory calibrated to ±1%
- Software selectable frequency range of
8 MHz to 125 kHz
- Individually programmable weak pull-ups
- Ultra Low-Power Wake-up
- Software tunable
• Analog Comparator module with:
- Two analog comparators
- Two-Speed Start-Up mode
- Crystal fail detect for critical applications
- Clock mode switching during operation for
power savings
- Programmable On-chip Voltage Reference
(CVREF) module (% of VDD)
• Power-Saving Sleep mode
- Comparator inputs and outputs externally
accessible
• Wide operating voltage range (2.0V-5.5V)
• Industrial and Extended temperature range
• Power-on Reset (POR)
• A/D Converter:
- 10-bit resolution and 8 channels
• Timer0: 8-bit timer/counter with 8-bit
programmable prescaler
• Power-up Timer (PWRT) and Oscillator Start-up
Timer (OST)
• Enhanced Timer1:
• Brown-out Reset (BOR) with software control
option
- 16-bit timer/counter with prescaler
- External Timer1 Gate (count enable)
• Enhanced Low-Current Watchdog Timer (WDT)
with on-chip oscillator (software selectable nomi-
nal 268 seconds with full prescaler) with software
enable
- Option to use OSC1 and OSC2 in LP mode as
Timer1 oscillator if INTOSC mode selected
• Enhanced USART Module:
- Supports RS-485, RS-232, and LIN 1.2
- Auto-Baud Detect
• Multiplexed Master Clear with weak pull-up or
input only pin
• Programmable code protection
- Auto-wake-up on Start bit
• High-Endurance Flash/EEPROM cell:
• In-Circuit Serial Programming™ (ICSP™) via two
pins
- 100,000 write Flash endurance
- 1,000,000 write EEPROM endurance
- Flash/Data EEPROM retention: > 40 years
Program
Memory
Data Memory
10-bit A/D
(ch)
Timers
8/16-bit
Device
I/O
Comparators
Flash
(words)
SRAM
(bytes)
EEPROM
(bytes)
PIC16F688
4096
256
256
12
8
2
1/1
© 2007 Microchip Technology Inc.
DS41203D-page 1
MICROCHIP [ MICROCHIP ]
