PIC16C5X
The PIC16C5X device contains an 8-bit ALU and
3.0
ARCHITECTURAL OVERVIEW
working register. The ALU is
a general purpose
The high performance of the PIC16C5X family can be
attributed to number of architectural features
arithmetic unit. It performs arithmetic and Boolean
functions between data in the working register and any
register file.
a
commonly found in RISC microprocessors. To begin
with, the PIC16C5X uses a Harvard architecture in
which program and data are accessed on separate
buses. This improves bandwidth over traditional von
Neumann architecture where program and data are
fetched on the same bus. Separating program and
data memory further allows instructions to be sized
differently than the 8-bit wide data word. Instruction
opcodes are 12-bits wide making it possible to have all
The ALU is 8-bits wide and capable of addition,
subtraction, shift and logical operations. Unless
otherwise mentioned, arithmetic operations are two's
complement in nature. In two-operand instructions,
typically one operand is the W (working) register. The
other operand is either a file register or an immediate
constant. In single operand instructions, the operand
is either the W register or a file register.
single word instructions.
A 12-bit wide program
memory access bus fetches a 12-bit instruction in a
single cycle. A two-stage pipeline overlaps fetch and
execution of instructions. Consequently, all instructions
(33) execute in a single cycle (200ns @ 20MHz)
except for program branches.
The W register is an 8-bit working register used for
ALU operations. It is not an addressable register.
Depending on the instruction executed, the ALU may
affect the values of the Carry (C), Digit Carry (DC),
and Zero (Z) bits in the STATUS register. The C and
DC bits operate as a borrow and digit borrow out bit,
respectively, in subtraction. See the SUBWFand ADDWF
instructions for examples.
The PIC16C52 addresses 384
x 12 of program
memory, the PIC16C54s/CR54s and PIC16C55s
address 512 x 12 of program memory, the
PIC16C56s/CR56s address 1K
memory, and the PIC16C57s/CR57s
PIC16C58s/CR58s address 2K x 12 of program
memory. All program memory is internal.
X
12 of program
and
A simplified block diagram is shown in Figure 3-1, with
the corresponding device pins described in Table 3-1.
The PIC16C5X can directly or indirectly address its
register files and data memory. All special function
registers including the program counter are mapped in
the data memory. The PIC16C5X has
a highly
orthogonal (symmetrical) instruction set that makes it
possible to carry out any operation on any register
using any addressing mode. This symmetrical nature
and lack of ‘special optimal situations’ make
programming with the PIC16C5X simple yet efficient.
In addition, the learning curve is reduced significantly.
1998 Microchip Technology Inc.
Preliminary
DS30453B-page 9
MICROCHIP [ MICROCHIP ]
