PIC16F7X
2.2.2.4
PIE1 Register
Note: Bit PEIE (INTCON<6>) must be set to
enable any peripheral interrupt.
The PIE1 register contains the individual enable bits for
the peripheral interrupts.
REGISTER 2-4:
PIE1 REGISTER (ADDRESS 8Ch)
R/W-0
PSPIE(1)
bit 7
R/W-0
ADIE
R/W-0
RCIE
R/W-0
TXIE
R/W-0
SSPIE
R/W-0
R/W-0
R/W-0
TMR1IE
bit 0
CCP1IE
TMR2IE
bit 7
bit 6
bit 5
bit 4
bit 3
bit 2
bit 1
bit 0
PSPIE(1): Parallel Slave Port Read/Write Interrupt Enable bit
1= Enables the PSP read/write interrupt
0= Disables the PSP read/write interrupt
ADIE: A/D Converter Interrupt Enable bit
1= Enables the A/D converter interrupt
0= Disables the A/D converter interrupt
RCIE: USART Receive Interrupt Enable bit
1= Enables the USART receive interrupt
0= Disables the USART receive interrupt
TXIE: USART Transmit Interrupt Enable bit
1= Enables the USART transmit interrupt
0= Disables the USART transmit interrupt
SSPIE: Synchronous Serial Port Interrupt Enable bit
1= Enables the SSP interrupt
0= Disables the SSP interrupt
CCP1IE: CCP1 Interrupt Enable bit
1= Enables the CCP1 interrupt
0= Disables the CCP1 interrupt
TMR2IE: TMR2 to PR2 Match Interrupt Enable bit
1= Enables the TMR2 to PR2 match interrupt
0= Disables the TMR2 to PR2 match interrupt
TMR1IE: TMR1 Overflow Interrupt Enable bit
1= Enables the TMR1 overflow interrupt
0 = Disables the TMR1 overflow interrupt
Note 1: PSPIE is reserved on 28-pin devices; always maintain this bit clear.
Legend:
R = Readable bit
- n = Value at POR reset
W = Writable bit
U = Unimplemented bit, read as ‘0’
’0’ = Bit is cleared x = Bit is unknown
’1’ = Bit is set
DS30325B-page 22
2002 Microchip Technology Inc.