PIC16F62X
17.0
ELECTRICAL SPECIFICATIONS
Absolute Maximum Ratings †
Ambient temperature under bias................................................................................................................. -40 to +125°C
Storage temperature .............................................................................................................................. -65°C to +150°C
Voltage on V
DD
with respect to V
SS
........................................................................................................... -0.3 to +6.5V
Voltage on MCLR and RA4 with respect to V
SS
..........................................................................................-0.3 to +14V
Voltage on all other pins with respect to V
SS
....................................................................................-0.3V to V
DD
+ 0.3V
Total power dissipation (Note 1)...........................................................................................................................800 mW
Maximum current out of V
SS
pin ...........................................................................................................................300 mA
Maximum current into V
DD
pin ..............................................................................................................................250 mA
Input clamp current, I
IK
(V
I
< 0 or V
I
> V
DD
).....................................................................................................................
±
20 mA
Output clamp current, I
OK
(Vo < 0 or Vo >V
DD
)...............................................................................................................
±
20 mA
Maximum output current sunk by any I/O pin..........................................................................................................25 mA
Maximum output current sourced by any I/O pin ....................................................................................................25 mA
Maximum current sunk by PORTA and PORTB....................................................................................................200 mA
Maximum current sourced by PORTA and PORTB ..............................................................................................200 mA
Note 1:
Power dissipation is calculated as follows: Pdis = V
DD
x {I
DD
-
∑
I
OH
} +
∑
{(V
DD
-V
OH
) x I
OH
} +
∑(V
O
l x I
OL
)
†
NOTICE:
Stresses above those listed under "Absolute Maximum Ratings" may cause permanent damage to the
device. This is a stress rating only and functional operation of the device at those or any other conditions above
those indicated in the operation listings of this specification is not implied. Exposure to maximum rating conditions
for extended periods may affect device reliability.
Note:
Voltage spikes below V
SS
at the MCLR pin, inducing currents greater than 80 mA, may cause latch-up.
Thus, a series resistor of 50-100
Ω
should be used when applying a "low" level to the MCLR pin rather
than pulling this pin directly to V
SS
.
©
1999 Microchip Technology Inc.
Preliminary
DS40300B-page 131
MICROCHIP [ MICROCHIP TECHNOLOGY ]
