PIC16F7X
FIGURE 12-2:
EXTERNAL CLOCK INPUT
OPERATION (HS OSC
CONFIGURATION)
12.2 Oscillator Configurations
12.2.1 OSCILLATOR TYPES
The PIC16F7X can be operated in four different oscil-
lator modes. The user can program two configuration
bits (FOSC1 and FOSC0) to select one of these four
modes:
OSC1
Clock from
Ext. System
PIC16F7X
(HS Mode)
OSC2
• LP
• XT
• HS
• RC
Low Power Crystal
Open
Crystal/Resonator
High Speed Crystal/Resonator
Resistor/Capacitor
12.2.2
CRYSTAL OSCILLATOR/CERAMIC
RESONATORS
TABLE 12-1: CERAMIC RESONATORS
(FOR DESIGN GUIDANCE
ONLY)
In XT, LP or HS modes, a crystal or ceramic resonator is
connected to the OSC1/CLKIN and OSC2/CLKOUT
pins to establish oscillation (Figure 12-1). The
PIC16F7X oscillator design requires the use of a parallel
cut crystal. Use of a series cut crystal may give a fre-
quency out of the crystal manufacturers specifications.
When in HS mode, the device can accept an external
clock source to drive the OSC1/CLKIN pin (Figure 12-2).
See Figure 15-1 or Figure 15-2 (depending on the part
number and VDD range) for valid external clock
frequencies.
Typical Capacitor Values Used:
Mode
Freq
OSC1
OSC2
XT
455 kHz
2.0 MHz
4.0 MHz
56 pF
47 pF
33 pF
56 pF
47 pF
33 pF
HS
8.0 MHz
16.0 MHz
27 pF
22 pF
27 pF
22 pF
Capacitor values are for design guidance only.
FIGURE 12-1:
CRYSTAL/CERAMIC
RESONATOROPERATION
(HS, XT OR LP
These capacitors were tested with the resonators
listed below for basic start-up and operation. These
values were not optimized.
OSC CONFIGURATION)
Different capacitor values may be required to produce
acceptable oscillator operation. The user should test
the performance of the oscillator over the expected
VDD and temperature range for the application.
(1)
C1
OSC1
To
Internal
Logic
XTAL
(3)
RF
See the notes at the bottom of page 92 for additional
information.
OSC2
SLEEP
PIC16F7X
(2)
RS
Resonators Used:
(1)
C2
455 kHz
2.0 MHz
4.0 MHz
8.0 MHz
16.0 MHz
Panasonic EFO-A455K04B
Murata Erie CSA2.00MG
Murata Erie CSA4.00MG
Murata Erie CSA8.00MT
Murata Erie CSA16.00MX
Note 1: See Table 12-1 and Table 12-2 for recom-
mended values of C1 and C2.
2: A series resistor (RS) may be required for AT
strip cut crystals.
3: RF varies with the crystal chosen.
2002 Microchip Technology Inc.
DS30325B-page 91
MICROCHIP [ MICROCHIP ]
