PIC10F200/202/204/206
TABLE 12-3: CALIBRATED INTERNAL RC FREQUENCIES – PIC10F200/202/204/206
Standard Operating Conditions (unless otherwise specified)
Operating Temperature
-40°C ≤ TA ≤ +85°C (industrial),
-40°C ≤ TA ≤ +125°C (extended)
AC CHARACTERISTICS
Operating Voltage VDD range is described in
Section 12.1 “DC Characteristics”.
Param
Freq
Tolerance
Sym
Characteristic
Min Typ†
Max Units
Conditions
No.
F10
FOSC
Internal Calibrated
INTOSC
± 1%
± 2%
3.96 4.00
3.92 4.00
4.04 MHz VDD=3.5V @ 25°C
4.08 MHz 2.5V ≤ VDD ≤ 5.5V
0°C ≤ TA ≤ +85°C (industrial)
4.20 MHz 2.0V ≤ VDD ≤ 5.5V
-40°C ≤ TA ≤ +85°C (industrial)
-40°C ≤ TA ≤ +125°C (extended)
Frequency(1,2)
± 5%
3.80 4.00
*
These parameters are characterized but not tested.
†
Data in the Typical (“Typ”) column is at 5V, 25°C unless otherwise stated. These parameters are for design
guidance only and are not tested.
Note 1: To ensure these oscillator frequency tolerances, VDD and VSS must be capacitively decoupled as close to
the device as possible. 0.1 μF and 0.01 μF values in parallel are recommended.
2: Under stable VDD conditions
FIGURE 12-3:
RESET, WATCHDOG TIMER AND DEVICE RESET TIMER TIMING –
PIC10F200/202/204/206
VDD
MCLR
30
Internal
POR
32
32
32
DRT
(2)
Timeout
Internal
Reset
Watchdog
Timer
Reset
31
34
34
(1)
I/O pin
Note 1: I/O pins must be taken out of High-Impedance mode by enabling the output drivers in software.
2: Runs on POR only.
DS41239D-page 70
© 2007 Microchip Technology Inc.
MICROCHIP [ MICROCHIP ]
