PIC10F200/202/204/206
For example, CLRF STATUS, will clear the upper three
bits and set the Z bit. This leaves the STATUS register
as 000u u1uu(where u= unchanged).
4.4
STATUS Register
This register contains the arithmetic status of the ALU,
the Reset status and the page preselect bit.
Therefore, it is recommended that only BCF, BSF and
MOVWFinstructions be used to alter the STATUS regis-
ter. These instructions do not affect the Z, DC or C bits
from the STATUS register. For other instructions which
do affect Status bits, see Section 10.0 “Instruction
Set Summary”.
The STATUS register can be the destination for any
instruction, as with any other register. If the STATUS
register is the destination for an instruction that affects
the Z, DC or C bits, then the write to these three bits is
disabled. These bits are set or cleared according to the
device logic. Furthermore, the TO and PD bits are not
writable. Therefore, the result of an instruction with the
STATUS register as destination may be different than
intended.
REGISTER 4-1:
STATUS REGISTER
R/W-0
GPWUF
bit 7
R/W-0
CWUF(1)
R/W-0
—
R-1
TO
R-1
PD
R/W-x
Z
R/W-x
DC
R/W-x
C
bit 0
Legend:
R = Readable bit
-n = Value at POR
W = Writable bit
‘1’ = Bit is set
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared x = Bit is unknown
bit 7
bit 6
GPWUF: GPIO Reset bit
1= Reset due to wake-up from Sleep on pin change
0= After power-up or other Reset
CWUF: Comparator Wake-up on Change Flag bit(1)
1= Reset due to wake-up from Sleep on comparator change
0= After power-up or other Reset conditions.
bit 5
bit 4
Reserved: Do not use. Use of this bit may affect upward compatibility with future products.
TO: Time-out bit
1= After power-up, CLRWDTinstruction or SLEEPinstruction
0= A WDT time-out occurred
bit 3
bit 2
bit 1
PD: Power-Down bit
1= After power-up or by the CLRWDTinstruction
0= By execution of the SLEEPinstruction
Z: Zero bit
1= The result of an arithmetic or logic operation is zero
0= The result of an arithmetic or logic operation is not zero
DC: Digit Carry/Borrow bit (for ADDWFand SUBWFinstructions)
ADDWF:
1= A carry from the 4th low-order bit of the result occurred
0= A carry from the 4th low-order bit of the result did not occur
SUBWF:
1= A borrow from the 4th low-order bit of the result did not occur
0= A borrow from the 4th low-order bit of the result occurred
bit 0
C: Carry/Borrow bit (for ADDWF, SUBWFand RRF, RLFinstructions)
ADDWF:
SUBWF:
RRFor RLF:
1= A carry occurred
1= A borrow did not occur Load bit with LSb or MSb, respectively
0= A carry did not occur 0= A borrow occurred
Note 1: This bit is used on the PIC10F204/206. For code compatibility do not use this bit on the PIC10F200/202.
© 2007 Microchip Technology Inc.
DS41239D-page 19
MICROCHIP [ MICROCHIP ]
